Weslo Body 245 Instruction Manual - Page 6

Upright 4 into the Frame 1. Attach the Upright

Get Weslo Body 245 PDF manuals and user guides View all Weslo Body 245 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 6 highlights

STEP 1 Fix the Front bottom tube (2) and the Rear bottom tube (3) onto the Main frame (1) with the Allen pan head screw (7) and Curved washer (9) as shown. STEP 2 A While another person holds the Upright (17) near the Frame (1), connect the Extension Wire (15) to the sensor Wire (12). Next, connect the Resistance Cable (16) to the 16 Lower Cable (11) in the following way: • See drawing A. Pull upward on the metal bracket on the Lower Cable (11), and insert the tip of the Resistance Cable (16) into the wire clip inside the metal bracket as shown. • See drawing B. Firmly pull the Resistance Cable (16) upward and slide it into the top of the metal bracket as shown. • See drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket together. Push the Wires (15, 12) and the Cables (16, 11) downward into the Frame (1). Tip: Do not pinch the wires and cables. Insert the Upright (4) into the Frame (1). Attach the Upright with four Screws (13), four plat Washers (8) and four Curved washer (9). Then Slide the cover (14) into the plastic frame. B Metallic support 911 C 166 Metallic support 911 6

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
6
STEP 1
Fix the Front bottom tube (2) and the Rear bottom
tube (3) onto the Main frame (1) with the Allen pan
head screw (7) and Curved washer (9) as shown.
STEP 2
While another person holds the Upright (17) near
the Frame (1), connect the Extension Wire (15) to
the sensor Wire (12).
Next, connect the Resistance Cable (16) to the
Lower Cable (11) in the following way:
• See drawing A. Pull upward on the metal bracket
on the Lower Cable (11), and insert the tip of the
Resistance Cable (16) into the wire clip inside the
metal bracket as shown.
• See drawing B. Firmly pull the Resistance Cable
(16) upward and slide it into the top of the metal
bracket as shown.
• See drawing C. Using pliers, squeeze the prongs
on the upper end of the metal bracket together.
Push the Wires (15, 12) and the Cables (16, 11)
downward into the Frame (1).
Tip: Do not pinch the wires and cables. Insert the
Upright (4) into the Frame (1). Attach the Upright
with four Screws (13), four plat Washers (8) and
four
Curved washer
(9).
Then Slide the cover (14) into the plastic frame.
A
B
C
6
11
11
16
Metallic
support
Metallic
support
16