Weslo Cadence 200cs English Manual - Page 5
Assembly - treadmill manual
View all Weslo Cadence 200cs manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
ASSEMBLY Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner. Assembly requires the included allen wrench and your own phillips screwdriver , adjustable wrenches , and 9/16" socket wrench . 1. Note: To identify small parts used during assembly, refer to the PART IDENTIFICATION CHART in the center of this manual. •Hazardous Voltage •Risk of Electric Shock •Unplug Treadmill before Assembly /Disassembly. With the help of a second person, carefully tip the treadmill onto its left side. Identify the Right Handrail (6), which has a large hole near the lower end. (Note: There may be identification decals on the Handrails.) Hold the Right Handrail in the position shown. Feed the end of the Wire Harness (22) into the hole in the lower end of the Right Handrail and out of the upper end of the Right Handrail. Hold a Frame Spacer (13) between the Right Handrail and the Frame. Attach the Right Handrail with a Frame Bolt (10), a Handrail Washer (11), and a Star Washer (33). Tip the treadmill onto its right side and attach the Left Handrail (not shown) as described above. Note: There will not be a wire harness in the Left Handrail. 2. Hold the Base (71) against the Right Handrail (6) and the Left Handrail (not shown), with the Base Pads (19) in the positions shown. Using a 9/16" socket wrench and the allen wrench, attach the Base (71) to the Right Handrail (6) with two Handrail Bolts (12), two Formed Washers (31), and two Nuts (42). Do not tighten the Nuts yet. Attach the Base to the Left Handrail (not shown) in the same way. Tighten all four Nuts. Insert the excess Wire Harness (22) up into the Right Handrail. With the help of a second person, raise the treadmill so the Base (71) is resting flat on the floor. 3. Using two adjustable wrenches, attach the Wheels (15) to the inside of the Base (71) with the two Wheel Bolts (14) and the two Nuts (42) as shown (only the right side is shown). Do not overtighten the Wheel Nuts; the Wheels should turn freely. 1 6 Bend 2 19 6 3 10 Large 11 Hole 33 22 13 55 12 42 22 31 71 19 14 15 71 42 5