Weslo Cadence 25 Treadmill User Manual - Page 8

3. With the help of a second person, raise the Uprights (53, 54) so that the Base (52) is flat on the floor as 3 shown. Next, position the front of the treadmill Frame (51) between the Uprights. See the inset drawing. Locate the wire inside of the lower end of the Right Upright (54). Secure the wire to the Wire Harness (98) using the included plastic tie. Then, pull the upper end of the wire until the end of the Wire Harness is extending from the indicated hole in the upper end of the Right Upright. Have a second person lift and hold the front end of the Frame (51). Hold a Frame Spacer (23) between the Right Upright (54) and the Frame. Attach the Right Upright and the Frame Spacer to the Frame with an M10 x 110mm Bolt (1), an M10 Washer (14), and an M10 Star Washer (9). Repeat this step on the left side of the treadmill. Note: There are no wires on the left side of the treadmill. Hole 53 54 23 Large Hole 51 98 Wire Tie 98 1 52 9 14 54 4. Turn the Console Assembly (91) face-down. Be careful not to scratch the face of the Console Assembly. 4 Identify the Right Handrail (55), which has a large hole in one side. Attach the Right Handrail (55) to the Console Assembly (91) with two M4.2 x 19mm Screws (4), an M5 x 16mm Screw (5), and an M5 Star Washer (12). 5 12 4 Large Hole 55 91 8