Weslo Cadence 255 Dr Treadmill English Manual - Page 7

6. Set the Console (11) in the Console Base (87). Make sure that no wires are pinched. Insert as much of the Wire Harness (53) as possible down into the hole in the right Handrail (4). Securely tighten the plastic tie nearest to the right Handrail. Pull any excess Wire Harness between the plastic ties tight and tighten the other plastic tie. Cut off the ends of the plastic ties. Cover the Wire Harness with the Wire Cover (10), and route the Wire Harness out of the hole in the side of the Wire Cover. Attach the Wire Cover to the back of the Console Base with two 3/4" Screws (5). Do not overtighten the Screws. Make sure that no wires are pinched before you attach the Console (11) to the Console Base (87). Tighten five 3/4" Screws (5) into the Console Base and the Console in the locations shown. Note: No 3/4" Screw goes into the hole indicated by the arrow. Do not overtighten the Screws. 7. Attach the Storage Latch (66) to the left Upright (38) with two 3/4" Screws (5). 6 Ties No 87 Screw 11 5 53 5 10 5 5 5 4 7 38 66 5 8. Make sure that all parts used in assembly are properly tightened before you use the treadmill. Keep the included allen wrench in a secure place. The allen wrench is used to adjust the walking belt (see page 13). To protect the floor or carpet, place a mat under the treadmill. 7