Weslo Cadence 45 Treadmill English Manual - Page 8
Be Damaged When The Power Is
View all Weslo Cadence 45 Treadmill manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
5. Insert the tab on one of the Handrail Brackets (5) into the slot in the right Upright (69). Attach 5 the Handrail Bracket with a 3/4" Screw (2). Attach the other Handrail Bracket to the left Upright (not shown) in the same way. 69 Slot Tab 5 2 6. Set the Console (43) face-down on a soft surface to avoid scratching the Console. Next, hold 6 a Handrail (71) near the console wire. Insert the console wire into the hole in the side of the Handrail. Grasp the tie and pull the console wire out of the hole in the top. Then, attach the ground wire to the Handrail with a Silver Ground Screw (96). Tie 71 2 2 2 Set the Handrail (71) on the Console (43). Console Wire Attach the Handrail with three 3/4" Screws (2). Make sure that the console wire is not Ground Wire pinched. Start all three Screws before tight- ening any of them; do not overtighten the Screws. Insert the excess ground wire back into 43 96 the opening in the Console. Attach the other Handrail (not shown) to the Console (43) as described above. Note: There are no wires on the other side. 7. Remove the tie holding the Wire Harness (42) to the right Upright (69). With the help of a second person, hold the Console (43) near the right Upright. 7 43 Remove the tie from the console wire. Connect the Wire Harness (42) to the console wire. See the inset drawing. The connectors should slide together easily and snap into place. If the connectors do not slide together easily and snap into place, turn one connector and try again. IF THE CONNECTORS ARE NOT CON- NECTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON. Then, insert the connectors and the excess wire into the right Upright (69). 42 69 Console Wire Console Wire 42 8