Weslo Cadence 910 User Manual - Page 5

MAINTENANCE AND TROUBLE-SHOOTING Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please call our Customer Service Department. PROBLEM: THE POWER DOES NOT TURN ON SOLUTION: a. Make sure that the power cord is plugged into a properly earthed outlet. (See HOW TO PLUG IN THE POWER CORD on page 7.) If an extension cord is needed, use only a 14-gauge cord of five feet (1,5 m) or less in length. b. After the power cord has been plugged in, make sure that the key is fully inserted into the console. c. Check the circuit breaker located on the treadmill frame near the power cord. If the switch protrudes as shown, the circuit breaker has tripped. To reset the circuit breaker, wait for five minutes and then press the switch back in. c Tripped Tripped Reset Reset PROBLEM: THE POWER TURNS OFF DURING USE SOLUTION: a. Check the circuit breaker located on the treadmill frame near the power cord (see the drawing above). If the circuit breaker has tripped, wait for five minutes and then press the switch back in. b. Make sure that the power cord is plugged in. c. Remove the key from the console. Reinsert the key fully into the console. d. If the treadmill still will not run, please call our Customer Service Department. PROBLEM: THE DISPLAYS OF THE CONSOLE DO NOT FUNCTION PROPERLY SOLUTION: a. Check the batteries in the console. If the batteries need to be replaced, see assembly step 6 on page 6. Most problems are the result of drained batteries. b. Remove the six screws from the hood. Carefully remove the hood. Locate the Reed Switch (8) and the Magnet (14) on the left side of the Pulley (5). Turn the Pulley until the Magnet is aligned with the Reed Switch. Make sure that the gap between the Magnet and the Reed Switch is about 1/8Ó (3 mm). If necessary, loosen the Clip Screw (9) and move the Reed Switch slightly. Retighten the Screw. Re-attach the hood, and run the treadmill for a few minutes to check for a correct speed reading. Top View 9 8 1/8Ó 5 14 ASSEMBLY Before beginning assembly, carefully read the following information and instructions: ¥ Assembly requires two people. ¥ Place all parts in a cleared area and remove the packing materials; do not dispose of the packing materials until assembly is completed. ¥ As you assemble the treadmill, be sure that all parts are oriented as shown in the drawings. The following tools (not included) are required for assembly: ¥ Two (2) adjustable spanners ¥ One (1) phillips screwdriver 1. With the help of a second person, carefully lay the 1 treadmill on its side. Position one of the Base Legs (55) on the base of the Upright (37) as shown. Make sure that the Base Leg Pads (31) and the Wheel (34) are in the indicated positions. Attach the Base Leg with two Base Leg Bolts (28), two Base Leg Washers (68), and two Base Leg Nuts (61). 37 Carefully turn the treadmill onto its other side. Assemble the other Base Leg (55) as described above. With the help of a second person, carefully raise the treadmill to the upright position so the Base Legs (55) are resting flat on the floor. 34 61 28 68 31 55 2. Hold the treadmill firmly with both hands, and lower 2 the treadmill to the floor. To decrease the possibili- ty of injury, bend your legs and keep your back straight. 12 5