Weslo Cadence 915 Uk Manual - Page 6
Attach the Console Base 45 to the Handrails
View all Weslo Cadence 915 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
3. Cut the plastic ties that hold the cage nuts in the lower end of each Handrail (87, 88). Position the Left Handrail (87) on the left Upright (37) as shown. Thread two Handrail Bolts (91) with Handrail Washers (90) into the left Upright and the Left Handrail. Do not tighten the Bolts yet. Have a second person hold the Console Base (45) and the Right Handrail (88) near the right Upright (37) as shown. Feed the excess Wire Harness (53) into the upper end of the Right Handrail, while pulling the excess from the bottom of the right Upright (37). Attach the Right Handrail (88) to the right Upright (37) with two Handrail Bolts (91) and Handrail Washers (90). Do not tighten the Bolts yet. Be careful not to pinch the Wire Harness (53). 4. Attach the Console Base (45) to the Handrails (87, 88) with four Screws (25). Feed the excess Wire Harness (53) into the upper end of the Right Handrail (88). Tighten all parts used in step 3. 3 90 91 37 4 53 88 5. The Console (49) requires two 1,5V batteries (not 5 included); alkaline batteries are recommended. Open the Battery Cover (48) as shown. Press two batteries into the battery compartment, with the negative ends of the batteries (marked "-") touching the springs. Close the Battery Cover. 53 45 87 88 90 90 90 91 91 91 37 45 25 25 87 49 48 Batteries 6. Make sure that all parts are properly tightened before you use the treadmill. Note: Some parts may be left over after assembly is completed. Save the included allen wrench for adjusting the walking belt. To protect the floor or carpet from damage, place a mat under the treadmill. 6