Weslo Cadence Dx5 English Manual - Page 8
Speed, Control
View all Weslo Cadence Dx5 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
DIAGRAM OF THE CONSOLE Monitor Display WED STEP ®STEP" (1)INSERT SAFEKEY CV PRESS ON/RESET BUTTON CID RESET SPEED, THEN SET TO DESIRED LEVEL FITNESS GUIDE"' WARM UP MT NAN AMOSIC PRIKORMANCII WIT 13 2 1 / SPUD TIME BUT ► ► ,,,„ 130 1. 13,„ SO 7D If os no us j ON Speed Control Key Clip console. Test the clip by carefully taking a few 42 a. steps backward until the key is pulled from the console. If the key is not pulled from the console, Off Yt f !if adjust-the position.-of the clip as needed:Men, re ve the key from the console. vP Follow the steps below to operate the console. 11 • ra Insert the key fully into the power switch. =- e Oat Note: Inserting the key will not turn on the display. The display will turn on when the ON/RESET button is pressed or when the walking belt is started. If you just installed batteries, the display will already be on. Reset the console and start the walking belt. STEP BY STEP CONSOLE OPERATION Before operating the console, make sure that the power cord is properly plugged in. (See HOW TO PLUG IN THE POWER CORD on page 7.) In addition, make sure that batteries are installed in the console. (See step 6 on page 6.) If there is a thin sheet of clear plastic on the console, remove it. Step onto the foot rails of the treadmill. Next, find the clip attached to the key (see the drawing above). Slide the clip onto your waistband. Insert the key into the Turn the speed control all of the way to the RESET position. Note: Each time the walking belt is stopped, the speed control must be turned to the RESET position before the walking belt canbarestarted. FITNESS GUIDE WWI UP WNW MOW RUIr Next, slowly turn the speed control until the walking belt begins to move at slow speed. Carefully