Weslo Momentum 410 Elliptical Uk Manual - Page 6

5. While another person holds the Upright (2) near the Frame (1), connect the Upper Wire Harness (37) to the Lower Wire Harness (36). Next, connect the Resistance Cable (25) to the Lower Resistance Cable (42) in the following way: • See drawing A. Pull upward on the metal bracket (A) on the Lower Resistance Cable (42), and insert the tip of the Resistance Cable (25) into the wire clip located inside the metal bracket. • See drawing B. Firmly pull the Resistance Cable (25) and slide it into the metal bracket (A) on the Lower Resistance Cable (42) as shown. • See drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket (A) together. Push the excess wire downward into the Frame (1). Next, slide the Upright (2) onto the Frame. Be careful not to pinch the wires. Attach the Upright with eight M8 x 20mm Button Screws (85), eight M8 Split Washers (63), and eight M8 Curved Washers (82). 5 2 63 82 63 82 85 63 82 82 63 85 82 63 25 Avoid pinching 42 the wires during 1 this step 82 37 63 36 A A 25 42 B C A 25 A 42 6. Orient a Handlebar (5) and a Handlebar Leg (6) as 6 shown. Insert the Handlebar into the Handlebar Leg. Attach the Handlebar with two M8 x 45mm Button Bolts (74), two M8 Curved Washers (82), two M8 Nylon Locknuts (58), and two M8 Acorn Covers (73). Repeat this step for the other Handlebar (not shown) and the other Handlebar Leg (not shown). 5 58 82 73 58 82 74 6 6