Weslo Momentum 620 Elliptical English Manual - Page 7

5. Have a second person hold the Upright (2) near the Frame (1). Connect the Upper Wire Harness (44) to the Lower Wire Harness (53). Push the excess wire downward into the Frame (1). Tip: Avoid pinching the Upper Wire Harness (44) and the Lower Wire Harness (53). Slide the Upright (2) onto the Frame (1). Attach the Upright with two M10 x 68mm Button Bolts (48), two M10 Split Washers (59), and two M10 Locknuts (33). Do not tighten the Button Bolts yet. 5 2 33 1 Avoid pinching the Upper Wire Harness (44) and the Lower 59 Wire Harness (53) 48 44 53 6. Identify the Left Handlebar (6), which is marked with a sticker. Insert the Left Handlebar (6) into one of the Handlebar Arms (5); make sure that the Handlebar Arm is turned so that the hexagonal holes are on the indicated side. Attach the Left Handlebar with two M6 x 38mm Button Bolts (50) and two M6 Locknuts (27). Make sure that the Locknuts are inside the hexagonal holes. Do not tighten the Button Bolts yet. Apply a small amount of the included grease to the left axle on the Upright (2). Orient a Handlebar Spacer (47) so that the curved side is facing the Upright (2). Slide the Handlebar Spacer onto the left axle on the Upright. Next, slide the Left Handlebar (6) onto the left axle on the Upright (2). Then, tap an Axle Cap (14) onto the axle. Repeat this step on the other side of the elliptical exerciser. 6 2 Grease 6 47 14 50 5 27 Hexagonal Holes Hexagonal Holes 7