Weslo Momentum 620 Elliptical English Manual - Page 8

7. Identify the Left Pedal Arm (11), which is marked with a sticker. 7 Orient the Left Pedal Arm (11) and a Pedal (13) as shown. Attach the Pedal to the Left Pedal Arm with two M6 x 45mm Flat Head Screws (36). Attach the other Pedal (not shown) to the Right Pedal Arm (not shown) in the same way. 36 13 11 8. Apply grease to the axle on the left Disc Crossbar (16) and to a Pedal Arm Bolt Set (40). 8 Slide the Left Pedal Arm (11) and a Wave Washer (64) onto the axle on the left Disc Crossbar (16). Next, slide an M10 Washer (35) onto an M10 x 25mm Patch Screw (22), and tighten the Patch Screw into the axle. Hold the left Handlebar Arm (5) inside the bracket on the Left Pedal Arm (11). Attach the Handlebar Arm to the Left Pedal Arm with the Pedal Arm Bolt Set (40). Do not overtighten the Pedal Arm Bolt Set; the Handlebar Arm must pivot freely. Repeat this step on the other side of the elliptical exerciser. 5 Grease 40 16 Grease See step 5. Tighten the M10 x 68mm Button Bolts (48). See step 6. Tighten the M6 x 38mm Button Bolts (50). 11 40 35 64 22 9. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the elliptical exerciser. 8