Weslo Momentum G 3.2 Elliptical English Manual - Page 7
Screws yet.
View all Weslo Momentum G 3.2 Elliptical manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
3. While a second person holds the Upright (2) near the Frame (1), connect the Wire Harness 3 (31) to the Reed Switch Wire (47). Next, connect the Resistance Cable (25) to the Lower Cable (42) in the following way: See inset drawing A. Pull upward on the metal bracket on the Lower Cable (42), and insert the tip of the Resistance Cable (25) into the wire clip inside the metal bracket. See inset drawing B. Firmly pull the Resistance Cable (25) and slide it into the metal bracket on the Lower Cable (42). See inset drawing C. Using pliers, squeeze together the prongs on the upper end of the metal bracket. 2 31 25 47 42 1 A 25 42 B 25 42 C 4. Tip: Avoid pinching the wires and cables during this step. Slide the Upright (2) onto the Frame (1). Attach the Upright (2) with three M8 x 20mm Screws (54), three M8 Split Washers (63), and three M8 Washers (55). Do not tighten the Screws yet. Then, attach the Upright (2) with two M8 x 60mm Bolts (90), four M8 Washers (55), and two M8 Locknuts (53). Do not tighten the Locknuts yet. 4 Avoid pinching the wires and cables 54 63 55 90 63 54 90 55 2 53 55 63 54 1 53 7