Weslo Pursuit 700s English Manual - Page 6
Handlebar Post. Attach the Handlebar Post
View all Weslo Pursuit 700s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
1. Carefully slide the Handlebar Post (3) onto the 1 Frame (1) while pulling the excess Reed Switch Wire (42) and Resistance Cable (31) up through the Handlebar Post. Attach the Handlebar Post with three M10 x 25mm Button Head Screws (53) and three M10 Split Washers (54). Be careful not to pinch the Reed Switch Wire or the Resistance Cable. 2. Loosen the Frame Knob (29) on the right side of the 2 Frame (1). Slide the Seat Frame (2) out until it stops. Tighten the Frame Knob. 42 31 53 54 53 1 3 53 54 29 3. The Console (33) requires two ÒAAÓ batteries (not 3 included)Ñalkaline batteries are recommended. Open the battery door on the back of the Console. Press two batteries into the Console. Make sure that the negative (Ð) ends of the batteries are touching the springs. Close the battery door. 1 2 33 Battery Door Batteries 4. Connect the Reed Switch Wire (42) to the console wire. Next, attach the Console (33) to the Handlebar Post (3) with four M4 x 16mm Screws (43). Push the Resistance Knob (32) onto the Resistance Control (10). Be sure that the mark on the Knob is correctly aligned. Back of Console 4 33 Console Wire 43 42 32 10 3 43 6