Weslo Pursuit G 3.1 Bike English Manual - Page 15
How To Adjust The Drive Belt
View all Weslo Pursuit G 3.1 Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
HOW TO ADJUST THE DRIVE BELT If the pedals slip while you are pedaling, even while the resistance is adjusted to the highest setting, the drive belt may need to be adjusted. Loosen the two M10 Flange Locknuts (37)-one on each side of the Eddy Mech (22). Then, tighten the two M6 Nuts (38) until the Drive Belt (not shown) is tight. When the Drive Belt is tight, tighten the M10 Locknuts. To adjust the drive belt, you must remove the pedals, the resistance knob cover, and the shields. 22 Using an adjustable wrench, turn the left pedal clockwise and remove it. Then, turn the right pedal counterclockwise and remove it. 38 Press the tabs on the sides of the resistance control and pull the 37 Resistance Knob (14) 14 upward off the resis- Tab Tab tance control. See the EXPLODED DRAWING on page 19. Remove the four M3.5 x 19mm Screws (43) and the six M4 x 19mm Screws (27) from the Left and Right Shields (9, 10). Then, remove the Left and Right Shields. When the drive belt is correctly adjusted, reattach the shields, the resistance knob, and the pedals. 15