Weslo Pursuit R 2.2 Bike English Manual - Page 7
See drawing A., See drawing B., See drawing C., Tip: Avoid pinching the wires and cables., Avoid
View all Weslo Pursuit R 2.2 Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
2. Remove the screw (not shown) and the cardboard tube (not shown) from the Frame (1) if 2 necessary. Discard the screw and the cardboard tube. Orient the Front Stabilizer (2) so that the large holes face the Frame (1). Attach the Front Stabilizer (2) to the Frame (1) with two M10 x 70mm Screws (33). 33 2 Large Holes 1 3. While a second person holds the Upright (13) near the Frame (1), connect the Extension Wire (23) to the Reed Switch Wire (39). Next, connect the Resistance Cable (19) to the Lower Resistance Cable (29) in the following way: • S ee drawing A. Pull upward on the metal bracket on the Lower Resistance Cable (29), and insert the tip of the Resistance Cable (19) into the wire clip inside the metal bracket. • S ee drawing B. Firmly pull the Resistance Cable (19) upward and slide it into the top of the metal bracket. • S ee drawing C. Using pliers, squeeze the prongs on the upper end of the metal bracket together. Insert the wires and cables into the Frame (1). Tip: Avoid pinching the wires and cables. Insert the Upright (13) into the Frame (1). Attach the Upright (13) with three M8 x 15mm Screws (34) and three M8 Split Washers (50). 3 13 19 29 34 50 Avoid pinching the wires and cables 23 39 34 50 1 A B C Metal Bracket 19 19 29 7