Weslo Pursuit R 3.2 Bike English Manual - Page 19
Next, loosen the M6 x 20mm Hex Screw 31. Then
![]() |
View all Weslo Pursuit R 3.2 Bike manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
HOW TO ADJUST THE DRIVE BELT If you can feel the pedals slip while you are pedaling, even when the resistance is at the highest level, the drive belt may need to be adjusted. To adjust the drive belt, you must first remove the right pedal and the right shield as described below. Using an adjustable wrench, turn the right pedal counterclockwise and remove it. Next, remove all of the screws from the left and right shields; there are two sizes of screws in the shields-note which size of screw you remove from each hole. Then, gently pull the right shield away from the frame. Next, loosen the M6 x 20mm Hex Screw (31). Then, tighten the M10 x 50mm Hex Screw (66) until the Drive Belt (35) is tight. When the Drive Belt (35) is tight, tighten the M6 x 20mm Hex Screw (31). Then, reattach the right shield and the right pedal. 35 31 66 19
![](/manual_guide/products/weslo-pursuit-r-32-bike-english-manual-8b64f4c/19.png)