Weslo Sport 100 Uk Manual - Page 10

10. Set the Console (2) on the Console Base (45). Insert the excess Wire Harness (53) into the large hole in the side of the Right Handrail (5). Securely tighten the plastic ties on the bottom of the Console Base to prevent the Wire Harness from slipping. Then, cut off the ends of the plastic ties. Attach the Console (2) to the Console Base (45) with four 3/4" Screws (77) and two 1/2" Screws (92). Start all six Screws before tightening them; do not overtighten the Screws. See drawing 10a. Lower the Uprights (32, 37) until the Handrails (4, 5) are touching the floor. Position the Uprights so that the treadmill Frame (21) is centred between them. Firmly tighten the four Upright Bolts (28). Then, raise the Uprights back to the vertical position. 10 2 Ties 53 5 77 92 10a 32, 37 4, 5 21 45 77 28 11. Attach the Latch Housing (25) and the Latch Spacer (99) to the Left Upright (32) with two 3/4" Screws (77). Next, remove the latch knob from the latch pin. Make sure that the collar and the spring are on the pin, and insert the pin into the Latch Housing. Then, tighten the knob back onto the pin. Lift the treadmill frame to the storage position (see page 14). Make sure that the frame is centred between the Handrails (not shown). Firmly tighten the bolts and screws used in assembly steps 3 through 7. 11 Knob 99 25 77 Large Hole 32 Spring Collar Pin 12. Insert one of the Incline Legs (47) into the right side of the Frame (21) as shown, and adjust the Incline Leg to 12 46 the desired height. (Note: The Incline Leg can be ad- justed to any of four positions to vary the intensity of your exercise.) Next, fully insert an Incline Pin (46) into the Frame and the Incline Leg, and turn the Incline Pin to the "locked" position shown in the inset drawing. 46 Insert the other Incline Leg (not shown) and Incline Pin (46) into the left side of the Frame (21) in the same way. 47 CAUTION: Before using the treadmill, make sure that both Incline Pins are fully inserted at the same height. In addition, make sure that both incline pins are inserted from the direction shown. Do not use 46 the treadmill without the Incline Pins. Lower the treadmill (see HOW TO LOWER THE 21 TREADMILL FOR USE on page 15). 13. Make sure that all parts are properly tightened before you use the treadmill. Note: Extra hardware may be included. Keep the included hex keys in a secure place. The large hex key is used to adjust the walking belt (see page 17). To protect the floor or carpet, place a mat under the treadmill. 10