Weslo Vector 402 Uk Manual - Page 5
Tighten the Adjustment Handle 53 onto the Upright
View all Weslo Vector 402 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
3. Slide the two slots in the Handlebar Clamp (42) onto the 3 two indicated tabs on the Upright (13). Lift the bottom of the Handlebar Clamp away from the Upright. Insert the Handlebar (15) between the Handlebar Clamp and the Upright. Centre the Handlebar and rotate it to the desired position. Tighten the Adjustment Handle (53) onto the Upright (13). Note: The adjustment handle works like a span- ner. Turn the Handle counterclockwise, pull it away from the Upright, turn it clockwise, push it toward the upright, 13 and then turn it counterclockwise again. 4. The Console (16) requires three 1.5V (AA) batteries; 4 alkaline batteries are recommended. Insert three bat- teries into the Console. Make sure that the batteries are oriented as shown by the diagram inside the Console. 15 42 53 Batteries 16 5. Hold the Console (16) near the Upright (13). Insert the console cable and the console wire into the indicated 5 hole and down through the Upright. Attach the earth 16 wire to the Upright with the Earth Screw (27). Earth Attach the Console (16) to the Upright (13) with four Wire M5 x 12mm Screws (49). Be careful to avoid pinching the wires. 27 49 Hole 49 Console Wire Console Cable 13 Be careful to avoid pinching the wires. 5