WestBend 41125 Instruction Manual - Page 4
Assembling Your Stand Mixer Using Your Stand Mixer
View all WestBend 41125 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
ASSEMBLING YOUR STAND MIXER Your mixer requires some assembly before using. Do not plug cord into electrical outlet until after mixer is assembled and ready for operation. 1. To attach mixer to stand, press and hold down mixer release lever located on the back of the mixer stand. Position mixer head on stand so metal pin on underside of mixer fits into groove on mixer stand. Make sure mixer is securely attached to stand before using. NOTE: Mixer should not be used as a hand mixer. It must always be used on the stand. 2. Place turntable onto platform of stand, aligning extension on underside into correct opening for the size bowl being used, Small or Large. Lip on underside of bowl will fit into groove on turntable. 3. To insert beaters or dough hooks, press the lock release button located on side of mixer stand, lift mixer head up until it stops. The beater or dough hook with the round collar fits into the round socket of the mixer head. The beater with the hexagon collar fits into the hexagon socket of the mixer head. Insert beaters by pushing shaft into socket, turning slightly if needed until they lock in place. Beaters must be inserted into correct socket, as they are not interchangeable. USING YOUR STAND MIXER 1. Make sure speed control dial is set at the OFF position and mixer is securely attached to the stand before using. NOTE: Mixer should not be used as a hand mixer. Use only on stand. 2. Position turntable according to size bowl being used. Position bowl onto turntable. 3. Insert beaters or dough hooks into correct sockets. 4. Add ingredients to bowl as recipe directs. Plug cord into a 120 volt, AC electrical outlet only. Turn speed control dial to start mixing. Always begin mixing at a lower speed setting to prevent spattering, then increase to desired speed for mixing task. Speed setting can be adjusted during operation by turning dial forward and back. Use mixing guide as reference by aligning speed setting with indicator line. A red light will illuminate next to the setting that was selected. If you need to scrape the bowl during use, always turn mixer off, scrape then continue mixing. 5. When mixing is complete, turn speed control dial to OFF position and unplug cord from electrical outlet. Press the lock release button and lift mixer head up until it stops. Press the beater/hook release button located on side of mixer head and remove the beaters/hooks. NOTE: Do not try to pull the beaters/hooks out of the mixer head without pressing the beater release button as damage to the mixer head could occur. • A small amount of smoke and/or odor may occur upon heating due to the release of manufacturing oils - this is normal. 4