WestBend 82515 Instruction Manual - Page 3

Stir Rod Kettle Holder Tilt Door "ON/OFF" Switch Kettle Cover Kettle Release Tab Cabinet Door Popping Kettle with Cord Popcorn Scoop and Measuring Cup and Spoon BEFORE USING FOR THE FIRST TIME Please check all packaging material carefully before discarding. Accessory parts may be contained within the packaging material. Wash kettle cover, stir rod, door, kernel catcher, screen, popcorn scoop, and measuring cup and spoon in warm, soapy water. Rinse and dry thoroughly. Use a soapy dishcloth to wipe the interior of the cabinet, then rinse with a damp, non-soapy cloth and dry thoroughly. Wash the interior of the kettle with a damp, soapy washcloth. Rinse and dry thoroughly. Do not immerse kettle in water and do not get water on the black electrical box or cord. USING YOUR THEATER POPCORN MACHINE 1. With the handle facing down, lift the cover to the ceiling of the popper, threading the post in the ceiling through the hole in the cover. The magnets will hold the cover up. Screw the stir rod clockwise into the post in the ceiling of the popper. 2. Hold the kettle vertically and press it against the kettle holder while placing the hooks over the bar to hang the kettle on the kettle hook. Lift the kettle so that it rests on the kettle release tab. Place the kernel catcher in the indent in the bottom of the cabinet floor, then place the screen on top. Plug the cord from the kettle into the outlet in the ceiling of the popper. DO NOT plug the kettle directly into a wall outlet. Install the tilt door, then the cabinet door. 3. Using the measuring spoon and cup provided, place two spoonfuls (2 tbsp.) of oil into the kettle followed by one to two cupfuls (¼ to ½ cup) of popcorn kernels, then bring down the kettle cover. Note: DO NOT attempt to pop more than two measuring cupfuls (½ cup) of popcorn at one time and DO NOT use more than two measuring spoonfuls (2 tbsp.) of oil when popping as damage to the kettle may occur. 4. Plug the cord from the cabinet into a 120 v, AC outlet ONLY. Close the cabinet door then turn the "ON/OFF" switch to " I " (on). The stir rod will spin, and the kettle will begin heating. 5. After about 3 minutes, popcorn will begin to pop, and eventually overflow into the cabinet. Continue until there is a pause of 2-3 seconds between pops. Turn English - 3