Whirlpool CAM2752TQ Installation Instructions - Page 2

Before you start... Your safety and the safety of others are very important. We have provided many important safety message in this manual and on your appliance. Always read and obey all safety messages. You can be killed or seriously injured if you don't immediately follow instructions. TThhiiss sisymthbeoslaafleetrytsayleorut stoymbol. potential hazards that can killor hurt you and others. All safety messages will be preceded by the safety alert symbol and the word =DANGER" or WVARNING". These words mean: You can be killed or seriously injured if you don't follow instructions. All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can happen if the instructions are not followed. Check location where washer will be installed, Proper installation is your responsibilily, Make sure you have everything necessary for correct installation, Do Not store or operate washer below 320F (0oC) (some water may remain in washer). Single washer installations require 12-inch (30 cm) minimum risers to provide an air cushion and prevent noise and damage to valves, Grounded electrical outlet is required, See Electrical requirements, Hot and cold water faucets: Must be within 4 feet (1,2 meters) of the back of the washer and provide water pressure 10 - 100 PSI (69-690 kPa), A pressure reduction valve should be used in the supply line where inlet pressure entering the building exceeds 100 PSI (690 kPa) to prevent damage to the washer mixing valve, Untape and open washer lid, Remove packages and hoses from washer, screws Front access to the pump area is available by removing 2 No, T20 Torx screws and then removing the front panel, Important: Observe all governing codes and ordinances. PAGE 2 Water heater: Set to deliver 120°F (49°C) water to the washer, Level floor: Maximum slope under washer- 1 inch (2,5 cm), A floor drain should be provided under the bulkhead, Prefabricated bulkheads with electrical outlets, water supply lines and drain facilities should be used only where local codes permit, Standpipe drain system: Needs a twoinch (5 cm) minimum carry-away capacily of 17 gallons (64,4 liters) per minute, Top of standpipe must be at least 39 inches (99 cm) high and no higher than 72 inches (183 cm) from bottom of washer, Support: Floor must be sturdy enough to support loaded washer weight of 315 pounds (143 Kg), ® Registered trademark of TEXTRON