Whirlpool ED5FHAXVS User Guide - Page 11

• Has the ice melted around the auger (metal spiral) in the ice bin? Empty the ice container. Use warm water to melt the ice if necessary. Cut Hazard Use a sturdy glass when dispensing ice. Failure to do so can result in cuts. Is the ice dispenser stalling while dispensing "crushed" ice? Change the ice button from "crushed" to "cubed." If cubed ice dispenses correctly, depress the button for "crushed" ice and begin dispensing again. • Has the dispenser arm been held in too long? Ice will stop dispensing when the arm is held in too long. Wait 3 minutes for dispenser motor to reset before using again. The water dispenser will not operate properly • Freezer door closed completely? Close the door firmly. If it does not close completely, see "The doors will not close completely." • Refrigerator connected to a water supply and the supply shutoff valve turned on? Connect refrigerator to water supply and turn water shutoff valve fully open. • Is the water pressure at least 30 psi (207 kPa)? The water pressure to the home determines the flow from the dispenser. See "Water Supply Requirements." • Kink in the home water source line? Straighten the water source line. • New installation? Flush and fill the water system. • Water filter installed on the refrigerator? The filter may be clogged or incorrectly installed. • Is a reverse osmosis water filtration system connected to your cold water supply? See "Water Supply Requirements" in either the Installation Instructions or the Use & Care Guide. Water is leaking from the dispenser NOTE: One or two drops of water after dispensing is normal. • Glass not being held under the dispenser long enough? Hold the glass under the dispenser 2 to 3 seconds after releasing the dispenser lever. • New installation? Flush the water system. See "Prepare the Water System" or "Water and Ice Dispensers." • Recently changed water filter? Flush the water system. See "Prepare the Water System" or "Water and Ice Dispensers." The dispenser water is not cool enough NOTE: Water from the dispenser is chilled to only 50°F (10°C). • New installation? Allow 24 hours after installation for the water supply to cool completely. • Recently dispensed large amount of water? Allow 24 hours for water supply to cool completely. • Water not been recently dispensed? The first glass of water may not be cool. Discard the first glass of water. • Refrigerator connected to a cold water pipe? Make sure the refrigerator is connected to a cold water pipe. See "Water Supply Requirements." ACCESSORIES To order replacement filters, call 1-800-442-9991 and ask for the appropriate part number listed below or contact your authorized Whirlpool dealer. In Canada, call 1-800-807-6777. Stainless Steel Cleaner and Polish: Order Part #4396095 Standard Filter: Order Part #4396841 (T2RFWG2) In Canada, Order Part #4396841 B (T2RFWG2) WATERFILTER CERTIFICATIONS Tr adenlar k/?_led_d Designation Whlrll_)OI DcIuxe 'I'l WC}2 WhlrluooI DcluxeT] WG2L State of Cahfornm Department of Health Services Water Trealment Device Certificate Number ()5- 1702 I)ate I_l_ed: April 6, 2{g15 _me R_,v)sed _eotemtx,r 7. 200_ Rerdacement ElemeRts T2RFWG2 Rated Service Capacity: 2(_) ga]s Rated Service Flow: 0 5 gpm Conditions of Certificatioa: Do _ot use with wa_eT tha_ is microbiological/y u_sa_ or of nnkno_ n quality, without adequam disinfcclion beam or after t_ sys_m 11