Whirlpool ED5VHEXVB User Guide - Page 16

Base Grille Water Filtration System Model PIWG2L/P2RFWG2 Capacity 200 Gallons (757 Liters) Model PIWG2/P2RFWG2 Capacity 200 Gallons (757 Liters) @ System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class I*; and against NSF/ANSI Standard 53 for the reduction of Lead, Mercury, Benzene, Toxaphene, and O-dichlorobenzene. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reduction of the substances listed below. The concentration of the indicated substances in water entering the system was reduced to a concentration less than or equal to the permissible limit for water leaving the system, as specified in NSF/ANSI Standards 42 and 53. Substance Reduction Aesthetic Effects NSF Reduction Requirements Average Influent Influent Challenge Concentration Maximum Effluent Average Effluent Minimum % Average % Reduction Reduction Chlorine Taste/Odor Particulate Class I* Contaminant Reduction Lead: @ pH 6.5 Lead: @ pH 8.5 Mercury: @ pH 6.5 Mercury: @ pH 8.5 Benzene O-Dichlorobenzene 50% reduction 85% reduction NSF Reduction Requirements 0.010 mg/L 0.010 mg/L 0.002 mg/L 0.002 mg/L 0.005 mg/L 0.6 mg/L 1.909 mg/L 5166666 #/mL Average Influent 143.33 ug/L 150 ug/L 0.0058 mg/L 0.00646 mg/L 0.015 mg/L 1.83333 mg/L 2.0 mg/L + 10% At east 10,000 part c es/mL Influent Challenge Concentration 0.15 mg/L + 10% 0.15 mg/L _+10% 0.006 mg/L + 10% 0.006 mg/L _+10% 0.015 mg/L _+10% 1.8 mg/L _+10% 0.05 mg/L ** 4200 #/mL Maximum Effluent 1.0 ug/L 1.0 ug/L 0.3 ug/L 0.8 ug/L 0.5 ug/L 160 ug/L 97.4 >99.9 Minimum % Reduction >99.3 >99.3 94.8 88.5 >96.7 91.1 >97.4 >99.9 Average % Reduction >99.3 99.3 96.4 94.9 >96.7 96.5 Toxaphene 0.003 mg/L 0.016 mg/L 0.015 mg/L _+10% 1 ug/L 0.001 mg/L >93.8 >93.8 Test Parameters: pH = 7.5 _+0.5 unless otherwise noted. Flow = 0.5 gpm (1.9 Lpm). Pressure = 60 psig (413.7 kPa). Temp. = 68°F to 71.6°F (2O°C to 22°C). Rated service capacity = 200 gallons (757 liters). • It is essential that operational, maintenance, and filter replacement requirements be carried out for the product to perform as advertised. • These contaminants are not necessarily in your water supply. While testing was performed under standard laboratory conditions, actual performance may vary. • Use replacement filter P2RFWG2, part #4396841. 2010 suggested retail price of $39.99 U.S.A./S54.95 Canada. Prices are subject to change without notice. Model PlWG2L/PlWG2: Style 1 - When the filter indicator reads 10%, order a new filter. When the indicator reads 0%, it is recommended that you replace the filter. Style 2 - When the filter indicator changes from green to yellow, order a new filter. When the indicator changes from yellow to red, it is recommended that you replace the filter. Style 3 - When the water filter status display changes from "GOOD" to "ORDER," order a new filter. When the filter indicator reads "REPLACE," it is recommended that you replace the filter. Style 4 - Press FILTER to check the status of your water filter. If the filter indicator light is yellow, order a new filter. If the filter indicator light is red, it is recommended that you replace the filter. Change the water filter cartridge every 6 months. If the water flow to the water dispenser or ice maker decreases noticeably before 6 months have passed, replace the water filter cartridge more often. The product is for cold water use only. Do not use with water that is microbiologically unknown quality without adequate disinfection system. unsafe or of before or after the Refer to the "Warranty" section for the Manufacturer's name, address and telephone number. Refer to the "Warranty" section for the Manufacturer's limited warranty. Application Guidelines/Water Supply Parameters Water Supply Water Pressure Water Temperature Service Flow Rate City or Well 30 - 120 psi (207 - 827 kPa) 33 ° - 100°F (0.6 ° - 37.8°C) 0.5 gpm (1.9 Lpm) @ 60 psi *Class I particle size: >0.5 um to