Whirlpool ED5VHEXVB User Guide - Page 5
Refrigerator - refrigerators
View all Whirlpool ED5VHEXVB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
6, Check for leaks. Tighten any connections (including connections at the valve) or nuts that leak. J _i _', A .........B....... Complete the Installation A. Tubeclamp B. Tubeclamp screw C. Copper tubing D. Compression nut E. Valveinlet 7, The ice maker is equipped with a built-in water strainer. If your water conditions require a second water strainer, install it in the 1/4"(6.35 mm) water line at either tube connection. Obtain a water strainer from your nearest appliance dealer. Style 2 1. Unplug refrigerator or disconnect power. 2. Remove and discard the black nylon plug from the gray water tube on the rear of the refrigerator. 3. If the gray water tube supplied with the refrigerator is not long enough, a V4" x 1/4"(6.35 mm x 6.35 mm) coupling is needed in order to connect the water tubing to an existing household water line. Thread the provided nut onto the coupling on the end of the copper tubing. NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten. Electrical Shock Hazard Plug into a grounded 3 prong outlet. Do not remove ground prong. Do not use an adapter. Do not use an extension cord. Failure to follow these instructions can result in death, fire, or electrical shock. 1. Plug into a grounded 3 prong outlet. 2. Flush the water system. See "Prepare the Water System" or "Water and Ice Dispensers." NOTE: Allow 24 hours to produce the first batch of ice. Allow 3 days to completely fill ice container. REFRIGERATOURSE AB C D EFG A. Refrigerator water tubing B. Nut (provided) C. Bulb D. Coupfing (purchased) E. Ferrule (purchased) F Nut (purchased) G. Household water line 4. Turn shutoff valve ON. 5. Check for leaks. Tighten any nuts or connections (including connections at the valve) that leak. Style 3 1. Unplug refrigerator or disconnect power. 2. Remove and discard the cap from the gray water tube. AB A. Cap B. Inlet 3, Using a compresston nut and sleeve, attach the copper tube to the water inlet. 4. Once secured, tighten the compression nut. Do not overtighten. 5. Check the connection by pulling on the copper tubing. Turn on water supply to refrigerator. Check for leaks. Tighten any nuts or connections that leak. For your convenience, your refrigerator controls are preset at the factory. When you first install your refrigerator, make sure that the controls are still preset. The Refrigerator Control and the Freezer Control should both be set to the "mid-settings." Style 1: Rotary Controls FREEZER REFRIGERATOR • @ 2 4 COLD l_S COLDER COLD 1 2_g. s COLDER Style 2: Slide Controls Freezer Refrigerator cold 1 2 A 3 4 colder off 1 2 =, 3 4 colder IMPORTANT: • Your product will not cool when the REFRIGERATOR Control is set to OFE The Refrigerator Control adjusts the refrigerator compartment temperature. The Freezer Control adjusts the freezer compartment temperature. Settings to the left of the midsetting make the temperature less cold. Settings to the right of the mid-setting make the temperature colder. Wait 24 hours before you put food into the refrigerator. If you add food before the refrigerator has cooled completely, your food may spoil. NOTE: Adjusting the Refrigerator and Freezer Controls to a higher (colder) than recommended setting will not cool the compartments any faster.