Whirlpool GFG461LVS Installation Instructions - Page 15

To Convert Gas Pressure Regulator 1. Remove storage drawer or warming drawer. See "Replace Oven Racks and Warming Drawer" section. 2. Locate gas pressure regulator at rear of storage or warming drawer compartment. NOTE: On models with a warming drawer, an access cover must be removed to access the gas pressure regulator. A To Convert Surface Burners 1. Remove burner cap. 2. Using a Phillips or Quadrex® screwdriver, remove the burner base. NOTE: Reinstall one of the screws through the range cooktop to hold the orifice spud holder in place while removing and replacing the orifice spuds. C A D A. Gas pressure regulator IMPORTANT: Do not remove the gas pressure regulator. 3. Remove plastic cover from gas pressure regulator cap. 4. Turn gas pressure regulator cap counterclockwise with a ⁵⁄₈" combination wrench to remove. NOTE: Do not remove the spring beneath the cap. F Side view before A LP LP BFD E B A. Igniter electrode B. Gas tube opening C. Burner cap D. Burner base 3. Apply masking tape to the end of a 7 mm nut driver to help hold the gas orifice spud in the nut driver while changing it. Press nut driver down onto the gas orifice spud and remove by turning it counterclockwise and lifting out. Set gas orifice spud aside. C A D NG NG C Side view after A. Plastic cover B. Gas pressure regulator cap with hollow end facing out C. Gas pressure regulator cap with solid end facing out D. Washer E. Gas pressure regulator cap F. Gas regulator shutoff valve (shown in the "open" position) 5. Turn over the gas pressure regulator cap and reinstall on regulator so that the solid end faces out and the marking "