Whirlpool GH6177XPQ Use and Care Guide - Page 9
TheADD30SEC.
UPC - 050946959344
View all Whirlpool GH6177XPQ manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
TheSTARcTontrowl illstarat nyfunction. Ifcookingisinterruptetdo,uchintgheSTARcTontropladwill resumtehepresectycle. Foraddedconveniencthee,"Startt"ouchpadisalsoavailabolen somedisplasycreensa,ndprovidethsesamefunctioansthe STARcTontropl ad. The Timer can be set in minutes and seconds, up to 90 minutes, and counts down the set time. NOTE: The Timer does not start or stop the oven. 8:16 A Thenumericpaal ds1-5sharefunctiowniththeEasyMinute controlsW. henoneofthesecontrolisstouche(dwhileno functionisoperatingth),eovenwillbegincookinagthighpower for 1-5minutesd,ependinognwhichpadistouchedA.fter cookinbgeginsth, eEasyMinutecontrolrseturntotheirnormal numericpaal dfunction. TheADD30SECc.ontrosl tartstheovenat 100%powefror 30secondsa,ndadds30secondosfcooktimewitheach additiontaoluchofthecontroOl. ncecookinbgeginsc,ookpower orcooktimemaybechangemd anualblyytouchintghe appropriadteisplayareaandenterintghenewsetting. TheCANCEpLadstopsmosftunctionesxcepftortheTimer, ChildLockandLearninMg ode. TheovenwillalsoturnoffwhenthedoorisopenedC. losethe doorandtouchSTARoTrthe"Continued"isplaayreato resume thecycleA. sensocrookincgyclemaynotberesumeidf interruptebdyopenintghedoor. (0010(, ) Menu A. Timer countdown When the Timer is in use, the oven can still operate. During an oven operation, "Timer" will appear in the upper, right-hand corner of the display. The countdown may also be seen by touching TIMER SET-OFR Touch "Return" to go back to the previous screen or wait for the timer to end. If the timer ends while oven is still operating, the tone will sound and the display will return to the set operating mode. To Set: Touch TIMER SET-OFF, enter desired time and touch "Start." The time can be reset during the countdown by touching TIMER SET-OFF, entering a new time, then touching START. To Cancel: Touch TIMER SET-OFF twice. Thisisa 12-houcrlocks, howinag.ma. ndp.mW. henpoweirs firstsupplietdotheoveno, raftear powefrailureth, e"Home" screewn illappear. ToSetClock:ToucCh LOCKa,ndfollowdirections. ToHideClockT: ouchCLOCKth, entouchCANCE"LH. omew" ill appeairnplaceofthetimeofdayondisplasycreen. ToDisplay Clock: Touch CLOCK, then touch START. Tones are audible signals, indicating the following: One tone • Valid entry(short beep) • End of Timer countdown (long tone) Two tones • Reminder (short beeps), repeat each minute for 15 minutes after the end-of-cycle tones • Between stages (short beeps) Three Tones • Invalid entry (short beeps) Four tones • End of cycle (long tones) To Disable Tones: Turn volume off using the "Hints & Settings" menu. The vent fan has 4 speeds ranging from Off to High. To protect the oven, the vent fan will automatically turn on at high speed if the temperature from the range or cooktop below gets too hot. It may stay on for up to 1 hour to cool the oven. When this occurs, the Vent Fan pad will not function. • A few seconds after the last time the Vent Fan pad is touched, the screen returns to the previous display. The first time the vent fan is turned on after power is connected to the oven, the fan will start at high speed. The next time the vent fan is turned on, it will start at the last speed used. To Turn Vent Fan On/Off: Touch VENT FAN to turn fan on, then touch "+" or "-" on the display screen to select fan speed. Touch the Vent Fan pad twice to turn the fan off (or once if Fan screen is active). The cooktop/countertop light has numerous brightness settings ranging from Off to High. The light can be turned on manually, or the Night Light can be programmed to come on automatically when the sensor detects low light level. See "Night Light" section. To Manually Turn Light On/Off: Touch the LIGHT control pad to turn light on. Touch "+" or "-" on the display screen to set desired brightness level. Touch LIGHT pad twice to turn light off (or once if Light screen is active).