Whirlpool GI5FSAXVY User Guide - Page 15

Waterfiltercertifications - 03

Page 15 highlights

The water and ice dispenser will not operate properly Refrigerator connected to a water supply and the supply shutoff valve turned on? Connect refrigerator to water supply and turn water shutoff valve fully open. Kink in the water source line? Straighten the water source line. New installation? Flush and fill the water system. See "Water and Ice Dispenser." Is the water pressure at least 35 psi (241 kPa)? The water pressure to the home determines the flow from the dispenser. See "Water Supply Requirements." Water filter installed on the refrigerator? Remove filter and operate dispenser. If water flow increases, the filter may be clogged or incorrectly installed. Replace filter or reinstall it correctly. Refrigerator door closed completely? Close the door firmly. If it does not close completely, see "The doors will not close completely." Recently removed the doors? Make sure the water dispenser wire/tube assembly has been properly reconnected at the bottom of the refrigerator door. See "Refrigerator Doors." Reverse osmosis water filtration system connected to your cold water supply? This can decrease water pressure. See "Water Supply Requirements." Water is leaking from the dispenser system NOTE: One or two drops of water after dispensing is normal. • Glass not being held under the dispenser long enough? Hold the glass under the dispenser 2 to 3 seconds after releasing the dispenser lever. New installation? Flush the water system. See "Water and Ice Dispenser." Recently changed water filter? Flush the water system. See "Water and Ice Dispenser." Water on the floor near the base grille? Make sure the water dispenser tube connections are fully tightened. See "Refrigerator Doors." Water from the dispenser is warm NOTE: Water from the dispenser is only chilled to 50°F (10°C). • New installation? Allow 24 hours after installation for the water supply to cool completely. • Recently dispensed large amount of water? Allow 24 hours for water supply to cool completely. • Water not been recently dispensed? The first glass of water may not be cool. Discard the first glass of water. • Refrigerator connected to a cold water pipe? Make sure the refrigerator is connected to a cold water pipe. See "Water Supply Requirements." WATERFILTERCERTIFICATIONS Trademark/Model Desianat(on UKF8t)O)AXX75t) 4690011-75( 67OO3523-75O Manufacturer: PcntaPure Jnc State of Califbrnia Department of Health Servmes Water Treatment Device CertificateNumber 03- 1583 Date Issue_ Septeml_r 16.2()03 Dale RcvJst, d: April 92 2004 Reelacement Elements UKFgt)O 1AXX Rated Service Capacity: 750 gal Rated Service Flow: 078 gpm Conditions of Certification: f)o not use where _ ater it microblo/ogic;dly ults_ or _lth warm" of tmki_own quality, excep{ thai _ystems cerdiled Jbr cyst reduction may be used on dlsinl>cted water_ that may contain filterable cysts 15

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36

The water and ice dispenser will not operate properly
Refrigerator
connected
to a water
supply and the supply
shutoff valve turned
on?
Connect
refrigerator to water
supply
and turn water shutoff
valve fully open.
Kink in the water
source line?
Straighten
the water source
line.
New installation?
Flush and fill the water system. See "Water
and Ice Dispenser."
Is the water pressure
at least 35 psi
(241
kPa)?
The water
pressure
to the home determines
the flow from the dispenser.
See "Water Supply
Requirements."
Water filter installed on the refrigerator?
Remove filter and
operate
dispenser.
If water flow increases, the filter may be
clogged
or incorrectly
installed.
Replace filter or reinstall
it
correctly.
Refrigerator
door closed completely?
Close the door firmly.
If it does not close completely,
see "The doors will not close
completely."
Recently
removed
the doors?
Make sure the water
dispenser
wire/tube
assembly
has been properly
reconnected
at the bottom
of the refrigerator
door. See "Refrigerator
Doors."
Reverse
osmosis water
filtration
system connected
to
your cold water
supply? This
can decrease water pressure.
See "Water Supply
Requirements."
Water is leaking
from
the dispenser system
NOTE: One or two drops
of water after dispensing
is normal.
Glass not
being
held under
the dispenser
long
enough?
Hold the glass under the dispenser
2 to 3 seconds
after
releasing the dispenser
lever.
New installation?
Flush the water system. See "Water and
Ice Dispenser."
Recently changed
water
filter?
Flush the water system. See
"Water and Ice Dispenser."
Water
on
the
floor near
the base
grille?
Make sure the water
dispenser
tube connections
are fully tightened.
See
"Refrigerator
Doors."
Water
from
the dispenser is warm
NOTE: Water from the dispenser
is only chilled to 50°F (10°C).
New installation?
Allow 24 hours after installation
for the
water supply
to cool completely.
Recently dispensed
large
amount
of water?
Allow 24 hours
for water supply to cool completely.
Water
not
been recently
dispensed?
The first glass of water
may not be cool. Discard
the first glass of water.
Refrigerator
connected
to a cold
water
pipe?
Make sure
the refrigerator
is connected
to a cold water pipe. See "Water
Supply
Requirements."
WATERFILTERCERTIFICATIONS
Trademark/Model
Desianat(on
UKF8t)O)AXX75t)
4690011-75(
67OO3523-75O
Manufacturer:
PcntaPure
Jnc
State of Califbrnia
Department
of Health
Servmes
Water Treatment Device
Certificate
Number
03- 1583
Date
Issue_
Septeml_r
16.2()03
Dale
RcvJst, d: April
92
2004
Reelacement
Elements
UKFgt)O
1AXX
Rated
Service
Capacity:
750
gal
Rated
Service
Flow:
078
gpm
Conditions
of Certification:
f)o
not use
where
_ ater it
microblo/ogic;dly
ults_
or
_lth
warm" of
tmki_own
quality,
excep{
thai
_ystems
cerdiled
Jbr
cyst reduction
may
be used
on
dlsinl>cted
water_
that
may contain
filterable
cysts
15