Whirlpool GMC305PRS Use and Care Manual - Page 5

ELECTRONICOVENCONTROL A B CD E CU_TO_ B_OIL ©©© COOK _ELAY TIr,_E _ltCE STOP TIr_ HOUR _IN M LK A. Oven setting pads B. Temperature pads C. Oven light D. Auto clean E. Electronic display J / HG E Microwave oven controls G. Lower oven off/cancel H. Start pad I. Clock pad J. Timersetand off _Minu_ pad L. Hourpad M. Electron_ clock control When power is first supplied to the appliance, "PF" will appear on the display. Press LOWER OFF/CANCEL to clear. If "PF" appears at any other time, a power failure has occurred. Press LOWER OFF/CANCEL and reset the Clock if needed. When the oven is in use, the display shows preheat time and the temperature and oven setting. When the oven is not in use, the display shows the time of day. When using Cook Time (on some models), the display will show either hours and minutes, or minutes and seconds. The Start pad begins any oven function except the Timer. If the Start pad is not pressed within 5 seconds after pressing a function pad, the "Start?" indicator light will flash as a reminder. On some models, "START?" will appear on the display. If the Start pad is not pressed within 4 to 5 minutes (depending on your model) after pressing a function pad, the oven display will return to the time of day mode and the programmed function will be canceled. The Off/Cancel pad stops any function except the Clock, Timer and Control Lock. The cooling fan may continue to operate after an oven function has been canceled, depending on oven temperature. This is a 12-hour clock and does not show a.m. or p.m. To Set: Before setting, make sure the oven, Timer and Timed Cooking are off. 1. Press CLOCK. 2. Press the HOUR or MIN "plus" (+) or "minus" (-) keypads to set the time of day. 3. Press CLOCK or START. To Disable: The clock time can be disabled so that it does not show on the display. To disable, press and hold CLOCK for 5 seconds. To display the clock time again, press and hold CLOCK for 5 seconds and the time of day will show on the display. The clock time should not have to be reset. Tones are audible signals, indicating the following: One tone • Valid pad press • Oven is preheated • Function has been entered Three tones • Invalid pad press Four tones • End of cycle • Reminder, repeating each minute after the end-of-cycle tones