Whirlpool LDR3822P Owners Manual - Page 5
Installation Clearances, Minimum installation spacing for recessed, area and closet installation
View all Whirlpool LDR3822P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 5 highlights
Installation Clearances The location must be large enough to allow the dryer door to open fully. Dryer Dimensions Front View *203/4" (527 mm) 31" (787 mm) 1" 237/8" (25 mm) (606 mm) Side View 36" (914 mm) 203/4" (527 mm) 1" (25 mm) 81/4" (210 mm) Back View 235/8" (600 mm) 31/4" (83 mm) 1" (25 mm) 117/8" (303 mm) Minimum installation spacing for recessed area and closet installation The following dimensions shown are for the minimum spacing allowed when the dryer is to be operated with, or without, the Stack Stand Kit. To purchase a Stack Stand Kit, see "Assistance or Service." ■■ Additional spacing should be considered for ease of installation and servicing. ■■ Additional clearances might be required for wall, door, and floor moldings. ■■ Additional spacing of 1" (25 mm) on all sides of the dryer is recommended to reduce noise transfer. ■■ For closet installation with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable. ■■ Companion appliance spacing should also be considered. Recessed or closet installation - Dryer only 14" (356 mm) 3" (76 mm) 18" (457 mm) 48 in. 2 (310 cm2) 3"* (76 mm) 1" (25 mm) 24 in. 2 (155 cm2) 1" (25 mm) Recessed area 1" (25 mm) 3" (76 mm) Closet door with vents Recessed or closet installation - Stacked 3"* (76 mm) 12" (305 mm) 3" (76 mm) 12" (305 mm) DRYER 48 in.2 (310 cm2) WASHER 1" (25 mm) 24 in.2 (155 cm2) 1" (25 mm) 1" (25 mm) Recessed area 3" (76 mm) Closet door with vents *Most installations require a minimum 5½" (140 mm) clearance behind the dryer for the exhaust vent with elbows. See "Venting Requirements." 5