Whirlpool RC8700EDB Use and Care Guide - Page 16

Ceramic Surface Units Installing You can install ceramic surface units in the left basin (Model RC8720ED) or both basins (Model RC8700ED) of your cooktop. NOTE: The pictures in this section show the ceramic surface unit installed in the left basin, where the receptacle is in the front wall of the basin. To get the ceramic surface unit accessory, order Part Number RCM30DB/DQ from a Whirlpool service company or dealer (see Step 2 on page 38) or call the Whirlpool Consumer Assistance Center toll-free 1-800-253-1301. To install: Terminal receptacle Terminal plug 1. Make sure the control knobs are turned off. 4. Slide the accessory towards the receptacle until the terminal plug is firmly set in receptacle. 2. If the grill grates, element, and grill-rocks are in place, remove them before installing ceramic surface units. Clean out any grease that may be in the basin. (See page 24 for more information.) Terminal receptacle Terminal plug 5. Lower the opposite end of the accessory into the cooktop until it is flush with the surface. 3. Position the accessory terminal plug towards the terminal receptacle. 16