Whirlpool UDT555SAHP Installation Instructions - Page 11
Connect Fill Hose To Elbow
View all Whirlpool UDT555SAHP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
REMOVE ACCESS PANEL 8. Remove access panel CONNECT ELBOW TO VALVE 11. Connect elbow to fill valve Elbow Using a 1/4" nut driver or Phillips screwdriver, remove the two screws attaching access panel to dishwasher. 9. Measure cabinet opening Tighten elbow until snug, and be sure that it faces toward channel in bottom of base. 12. Fill valve location Fill valve location Measure the height of cabinet opening from the underside of the countertop to the floor where dishwasher will be installed. Be sure to measure the lowest point on the underside of the countertop and the highest point on the floor. 10. Leveling leg adjustment CONNECT FILL HOSE TO ELBOW 13. Flexible line Extend leveling legs out from the dishwasher base, 1/4" less than the shortest opening height measured in cabinet opening. Turn leg counter clockwise to raise the dishwasher or clockwise to lower the diswasher. Flexible braided line: Confirm the flexible braided line is long enough. Attach flexible line to elbow then route hose out the bottom left channel under the dishwasher. Secure in channel with tape or wire ties. 11