Whirlpool UXD8630DY Owners Manual - Page 11
Determine Which Vent Direction Is Best for, Your Installation, Bottom Venting, Left or Right Venting
View all Whirlpool UXD8630DY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
5. Attach the support legs to the side of the vent box with 4 - 4 x 8 mm screws in each support leg. Adjust to dimension "Y" from the bottom of the vent box to the bottom of the support legs. Tighten screws. C A Left or Right Venting: 1. Using 2 or more people, place the downdraft vent system on its back. 2. Remove the 4 screws from the cover plate mounted to the face of the motor box and set them aside. Dim. "Y" B A. Motor box B. Support leg C. 4 x 8 mm screws (4) Determine Which Vent Direction Is Best for Your Installation When installed in a cabinet, vent system can exhaust through the bottom, left, or right of the cabinet. IMPORTANT: When using the 6" (15.2 cm) vent transition (supplied) for 6" round venting, only left or right venting is recommended. Bottom Venting: NOTE: If installing the vent damper in the down position, a wall or roof cap with a damper at the exit end of the vent system is required. ■■ Downdraft vent is shipped with blower in down-venting position, so no modification is required. ■■ If rear mounting of the blower motor is not required, go to the "Complete Installation" section. ■■ To mount the blower motor to the rear side of the vent box, go to the "Rear Mounting - Blower Motor" section. A G B C F D E A. Cover plate B. Cover plate screws (4) C. Cover plate keyhole slot shoulder screws (4) D. Motor mounting screws (4) E. Vent cover plate F. Motor box G. Vent cover screws (3) 3. Slide the cover plate up and slip it over the keyhole slot shoulder screws. Set the cover aside. 4. Remove 4 screws from the bottom of the motor box that hold the motor assembly to the motor box. NOTE: Disconnect the electrical wiring connection from motor if needed. 5. Remove 3 screws and the vent cover plate from the left or right side of the motor box for the venting direction to be used. 6. Rotate the blower motor assembly 90° to the left or right side to the chosen venting direction and secure to the blower box with motor mounting screws previously removed. Do not twist or bind the wires. 7. Install the vent cover plate over the rectangular opening in the bottom of the motor box and secure with vent cover screws. NOTE: Reinstall the electrical wiring connection to motor if removed. 8. Reinstall the cover plate to the face of the motor box and secure with 4 cover plate screws previously removed. 9. For mounting the blower motor to the back of the vent box, go to the "Rear Mounting - Blower Motor" section. Otherwise, go to the "Complete Installation" section. 11