Whirlpool UXD8636DY Owners Manual - Page 14
Complete Installation
View all Whirlpool UXD8636DY manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Complete Installation NOTE: The downdraft vent system is supplied with a 31/4" x 10" (8.3 cm x 25.4 cm) backdraft damper and a 6" (15.2 cm) round vent transition with damper. Refer to "31/4" x 10" (8.3 cm x 25.4 cm) Backdraft Damper" or "6" (15.2 cm) Round Vent Transition with Damper," depending upon the type of venting you are using. 2. Remove 4 screws attaching the terminal box cover. 31/4" x 10" (8.3 cm x 25.4 cm) Backdraft Damper 1. Attach the 3¼" x 10" (8.3 cm x 25.4 cm) backdraft damper to the vent opening in the blower motor box, using three 3.5 x 9.5 mm screws. A BA A A. 3.5 x 9.5 mm screws B. 3¼" x 10" (8.3 cm x 25.4 cm) backdraft damper 6" (15.2 cm) Round Vent Transition with Damper 1. Attach the 6" (15.2 cm) round vent transition to vent opening (left- or right-side venting only is recommended), using two 3.5 x 9.5 mm screws. A. Terminal box cover 3. Determine which direction (front or rear) the home power supply cable will enter the terminal box. Remove the appropriate knockout from the front or rear panel and install a 1/2" (12.7 mm) UL listed or CSA approved conduit connector. 4. Using 2 or more people, insert the downdraft vent into the countertop cutout. Position downdraft vent so it is centered in the cutout with the rear flange over the edge of the cutout and the rear of the vent box against the edge of the cutout. A G B C D A B A. 3.5 x 9.5 mm screws B. 6" (15.2 cm) round vent transition with damper E F A. Rear flange of downdraft vent B. Edge of cutout in countertop C. Rear of downdraft vent D. Cabinet back E. Lower support leg F. Cabinet floor G. Countertop 14