Whirlpool UXL5430BSS Use & Care Guide - Page 9

Transfer measurement A to the cabinet back wall. Measure from the underside of the cabinet. Mark the cutout as shown. Use a saber saw or keyhole saw to cut a round opening through the back of the cabinet and the exterior wall for the vent. Go to Step 3. Measure and mark the centerline location for the cutout in the cabinet top. Use a saber saw or keyhole saw to cut an opening for the vent. A B* C A C B A. Measurement A B. Centerline C. 6¼" (15.9 cm) round cutout Non-Vented (recirculating) Installation Through the Soffit/Cabinet Measure and mark the centerline of the cabinet to the soffit above. Measure from the bottom of the cabinet to the centerline of the where the vent will come through the soffit. Mark the location and use a saber saw or keyhole saw to cut a 5¾" (14.6 cm) hole for the vent cover. A B D A. Cutout B. See chart below. C. 7³⁄₄" (19.7 cm) centerline to cabinet front D. Centerline Cabinet Height 12" (30.5 cm) 15" (38.1 cm) cabinet or soffit installation 18" (45.7 cm) or 24" (61.0 cm) Hole Shape and Size A 6¼" deep x 8" wide (15.9 cm x 20.3 cm) rectangular opening in the cabinet top is required for damper transition clearance. A 6¼" (15.9 cm) diameter round opening is required. A 5¾" (14.6 cm) diameter round opening is required. For non-vented (recirculating) installations only, the range hood can be vented indoors through the top of the cabinet. For non-vented (recirculating) installations, charcoal filters are necessary. See the "Range Hood Care" section for instructions on installing charcoal filters. The Recirculation Kit Part Number W10490330 must be used. A. Vent cover B. Centerline 9