Whirlpool UXT4030AYB Use & Care Guide - Page 7

Install Range Hood 1. Lift the range hood up under cabinet and determine final location by centering beneath cabinet. Mark on the underside of cabinet the location of the 4 keyhole mounting slots on the range hood. Set range hood aside on a covered surface. A Power Supply Cable Installation 1. For direct wire installations, run the home power supply cable according to the National Electric Code or CSA standards and local codes and ordinances. There must be enough wiring from the fused disconnect (or circuit breaker) box to make the connection in the hood electrical terminal box. For optional power supply cord kit installations, follow the instructions in the "Make Electrical Connections" section. A. Keyhole slot 2. Use ¹⁄₈" (3 mm) drill bit and drill 4 pilot holes as shown. NOTE: Do not reconnect power until the installation is complete. 2. Remove the screw from the terminal box cover. Remove terminal box cover and set aside. A A. Drill pilot hole 3. Install the 4 - 4.5 mm x 13 mm mounting screws in pilot holes. Leave about ¹⁄₄" (6.4 mm) space between screw heads and cabinet to slide range hood into place. ¹⁄₄" (6.4 mm) Non-vent (recirculating) installations - Do not remove any knockouts. A B A. Terminal box cover B. Screw 3. Remove the power supply knockout from the top or rear of the vent hood (depending on the incoming location of your home power supply cable) and install a UL listed or CSA approved ¹⁄₂" strain relief. A A. Power supply knockout 4. Using 2 or more people, lift the hood into final position. Feed enough electrical wire through the ½" UL listed or CSA approved strain relief to make connections in the terminal box. Tighten the strain relief screws. 5. Position the range hood so that the large end of the keyhole slots are over the mounting screws. Then push the hood toward the wall so that the screws are in the neck of the slots. Tighten the mounting screws, making sure the screws are in the narrow neck of slots. 7