Whirlpool WDF330PAHS Use & Care Guide - Page 7
STEP 3, Select a Cycle cycles vary by model, Select Options options vary by model, STEP 4, Start or
![]() |
View all Whirlpool WDF330PAHS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
NOTE: For most water conditions, the factory setting will give good results. ■■ Check water hardness level to ensure there are no rings or spots on your dishware before adding rinse aid or adjusting the factory setting. ■■ If you have hard water or notice rings or spots, try a higher setting. Turn the arrow adjuster inside the dispenser by either using your fingers or inserting a flat-blade screwdriver into the fill - - - center of the arrow and turning. max - - --- --- - - -- STEP 4 Start or Resume a Cycle ■■ Run hot water at the sink nearest to your dishwasher until the water is hot. Turn off water. ■■ For best dishwashing results, water should be 120ºF (49ºC) as it enters the dishwasher. ■■ Push door firmly closed. The door latches automatically. Select the wash cycle, options and press START/RESUME or press START/RESUME to repeat the same cycle and options as in the previous wash cycle. For models with controls on top of the door, select wash cycle, option, and press START/RESUME within 4 seconds of closing the door. STEP 3 Select a Cycle (cycles vary by model) See "Cycle and Option Descriptions" charts in the following section. Heavier cycles and options affect cycle length. ■■ You can add an item anytime at the beginning of the cycle. Open the door slowly and add the item. Close the door firmly. Press START/RESUME. Select Options (options vary by model) See "Cycle and Option Descriptions" charts in the following section. You can customize your cycles by pressing the options desired. 7
![](/manual_guide/products/whirlpool-wdf330pahs-use-care-guide-b0e07c0/7.png)