Whirlpool WDF560SAFW Use & Care Guide - Page 10

CONTROLS AND CYCLE STATUS CONTROL PURPOSE COMMENTS Press to start or resume a wash cycle. If the door is opened during a cycle or the power is interrupted, the Start/Resume button LED flashes. Cycle will not resume until door is closed and Start/Resume is pressed. Press to cancel wash cycle. Close the door firmly. Press and hold START/RESUME or 3 seconds. The dishwasher starts a 2-minute drain (if needed). Let dishwasher drain completely. To follow progress of The Clean indicator glows when a cycle is finished. your dishwasher cycle. NOTE: Indicators shown are not available on all models. If you select the Sani Rinse option, when the cycle is finished, the "Sanitized" indicator glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the end of the cycle. This can happen if the cycle is interrupted, or water could not be heated to required temperature. The light goes off when you open and close door or when you cancel the cycle. Dishwasher Features Your Whirlpool dishwasher may have some or all of these features. Removable Top Rack The removable top rack allows you to wash larger items such as pots, roasters, and cookie sheets in the bottom rack. IMPORTANT: Remove dishes prior to removing the top rack from dishwasher. To remove the rack 1. To gain access to the track stops, pull the upper rack forward about halfway out of the tub. 2. Press on the edge of the ridged area on the track stop while tipping the track stop toward the center of the dishwasher. This action releases a small retaining tab that locks the track stop to the track. (See "Track stop - Left.") Track stop - Left NOTE: It is helpful to use two hands. Take special note of the orientation of the track stops 3. With the retaining tab released, pull the track stop straight toward the opposite track to remove it. 4. After removing both track stops, carefully pull the top rack out of the tracks by rolling it toward you. 5. Replace the track stops by coming up from under the track and slipping the track stop into the lower slot of the track (See "Track stop - Right.") and rotate the track stop into place. Then press on the edge of the ridged area while pushing the track stop straight toward the track. This action locks the retaining tab back into place. 6. Test the track stop by pulling it toward the opposite track to ensure that it is locked in place. To replace the rack 1. Gently pull the tracks forward in dishwasher until they stop. Remove track stops. (See steps 1-3 above.) 2. Place the back wheels on each side of the rack into the track and roll the rack into the tracks, but do not push the rack all the way into the tub. 3. Insert front rack wheels on each side of the rack into the track. 4. Slide the rack into the dishwasher. Track stop - Right 5. Replace the track stops by coming up from under the track and slipping the track stop into the lower slot of the track (See "Track stop - Right.") and rotate the track stop into place. Then press on the edge of the ridged area while pushing the track stop straight toward the track. This action locks the retaining tab back into place. 6. Test the track stop by pulling it toward the opposite track to ensure that it is locked in place. IMPORTANT: Be sure that the track stops are locked in place and cannot be easily removed. They keep the rack from coming out of the track. 10