Whirlpool WDT720PADM Use & Care Guide - Page 9

OPTION SELECTIONS OPTIONS CAN BE SELECTED WITH ADDED TIME WHAT IT DOES TO CYCLE ADDED WATER GALLONS (LITERS) Dries dishes with heat. This option, with the use of Sensor Uses heating 0:08 to 0:46 0 rinse aid, will provide the best drying performance. Heavy element to speed Plastic items are less likely to deform when loaded in Normal drying times. the top rack. Use Heat Dry for optimum dry 1-Hour Wash Heat Dry option performance, Turn the Heat Dry option off for air dry. Soak & Clean defaults to On when any cycle is selected except for 1-Hour Wash. Runs dishwasher at a later time. Select a wash cycle Available with Delays start of a 0:00 0 and options. Each time you press the delay button it will display the next available delay time. Press any cycle cycle up to 24 hours. DELAY. Press START/RESUME. Close door firmly. NOTE: The dishwasher remembers the last Delay you selected. To reset the delay time to something other than what is displayed, continue to press the Delay button until the desired delay time is reached. NOTE: Anytime the door is opened (such as, to add a dish); START/RESUME must be pressed again to resume delay countdown. Avoids unintended use of dishwasher between cycles, or cycle and option changes during a cycle. To turn on Lock, press and hold SANI RINSE/CONTROL LOCK or DELAY (depending on model) for 3 seconds. Control Lock light will stay on for a short time, indicating that it is activated, and all buttons are disabled. If you press any button while your dishwasher is locked, light flashes 3 times. Dishwasher door can still be opened/closed while the controls are locked. To turn off Lock, press and hold SANI RINSE/CONTROL LOCK or DELAY (depending on model) for 3 seconds. Light turns off. NOTE: If your model requires you to press and hold DELAY to lock controls, Control Locked LED will be on or off to indicate whether Control Lock is active or not. CONTROLS AND CYCLE STATUS CONTROL PURPOSE COMMENTS Press to start or resume a wash cycle. If the door is opened during a cycle or the power is interrupted, the Start/Resume button LED flashes. Cycle will not resume until door is closed and START/RESUME is pressed. NOTE: If Start/Resume button is located on top of door, push door firmly closed within 3 seconds of pressing START/RESUME. If door is not closed within 3 seconds, Start/Resume button LED will flash, an audible tone will be heard (on some top control models), and cycle will not start. Press to cancel wash cycle. Close the door firmly. The dishwasher starts a 2-minute drain (if needed). Let dishwasher drain completely. Press and hold START/RESUME for 3 seconds. To follow progress of The Clean indicator glows when a cycle is finished. your dishwasher cycle. If you select Sani Rinse option, when cycle is finished, the "Sanitized" indicator glows. NOTE: Indicators shown If your dishwasher did not properly sanitize your dishes, the light flashes at the end of are not available on all the cycle. This can happen if the cycle is interrupted, or water could not be heated to models. required temperature. The light goes off when you open and close door or press CANCEL. 9