Whirlpool WDT730PAHZ Owners Manual - Page 10

CONTROLS AND CYCLE STATUS Control Purpose Comments To start or resume a wash cycle. If the door is opened during a cycle or the power is interrupted, the Start/Resume LED flashes. The cycle will not resume until Start/Resume is pressed and the door is closed. NOTE: Push door firmly closed within 4 seconds of pressing Start/Resume or the dishwasher will not start. If door is not closed within 4 seconds, the Start/Resume LED will flash when the door is closed. To cancel a wash Press and hold CANCEL/DRAIN for 3 seconds. Close the door firmly. The cycle. dishwasher starts a 2-minute drain (if needed). Let dishwasher drain completely. To inform you that the dishes have been sanitized. If you select the Sani Rinse option, when the cycle is finished, the Sanitized indicator on the control panel glows. If your dishwasher did not properly sanitize your dishes, the Sanitized indicator flashes at the end of the cycle. This can happen if the cycle is interrupted or if water could not be heated to required temperature. The indicator goes off when you open and close door or press Cancel/Drain. Dishwasher Features Silverware Basket Splittable Silverware Basket The splittable silverware basket can be separated and placed in various locations in the lower rack. Load flatware and utensils into both sections or just one, depending on your load. To split the basket: Hold the basket firmly along the sides. Unlock the baskets. Silverware basket lids: Use silverware basket lids to provide optimal spacing and best cleaning performance. Mix silverware types to keep them separated. Load knives down, forks up, and alternate spoons, for best cleaning results. NOTE: If your silverware does not fit into the designated slots, push tabs inward on either end and lift lid off of the silverware baskets. Cup Shelves Fold down the extra shelf on the top rack to hold additional cups, stemware, or long items such as utensils and spatulas. For best results on cups, stagger the spacing so that the cups on the shelf are not directly above the cups below. EZ-2-Lift™ Top Rack Adjuster You can raise or lower the top rack to fit tall items in either the top or bottom rack. Adjusters are located on each side of the top rack. To raise the rack: Press both rack adjuster thumb levers and lift the rack until it is in the up position and level. To lower the rack: Press both rack adjuster thumb levers and slide the rack to its down position and level. NOTE: The top rack must be level. Removable Top Rack The removable top rack allows you to wash larger items such as pots, roasters, and cookie sheets in the bottom rack. IMPORTANT: Remove dishes prior to removing the top rack from the dishwasher. To remove the rack: 1. To gain access to the track stops, pull the upper rack forward about halfway out of the tub. 2. Press on the edge of the ridged area on the track stop while tipping the track stop toward the center of the dishwasher. This action releases a small retaining tab that locks the track stop to the track (see Track stop - left). NOTE: It is helpful to use two hands. Take special note of the orientation of the track stops. Track stop - left 3. With the retaining tab released, pull the track stop straight toward the opposite track to remove it. 4. After removing both track stops, gently pull the top rack out of the tracks by rolling it toward you. 10