Whirlpool WDT780SAEM Use & Care Guide - Page 10

Dishwasher Features

Page 10 highlights

CONTROLS AND CYCLE STATUS CONTROL PURPOSE COMMENTS To follow progress of The Clean indicator glows when a cycle is finished. your dishwasher cycle. If you select the Sani Rinse option, when the cycle is finished, the "Sanitized" indicator NOTE: Indicators shown glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the are not available on all end of the cycle. This can happen if the cycle is interrupted, or water could not be models. heated to required temperature. The light goes off when you open and close door or press CANCEL. Dishwasher Features Your Whirlpool dishwasher may have some or all of these features. TargetClean™ Wash Area The TargetClean™ wash area is located at the back of the lower level rack. NOTE: You must select the TargetClean™ wash option to use this feature. Make sure items do not interfere with the water feed tube, spray arms, or TargetClean™ spray jets. Back of dishwasher ■ Load pans, casserole dishes, etc. in the back of the lower dish rack with the soiled surfaces facing the TargetClean™ spray jets. ■ Only one row of items may face the TargetClean™ spray jets. Stacking, overlapping or nesting items will keep the TargetClean™ spray jets from contacting all of the surfaces. To remove the basket from the door 1. Grasp the silverware basket by the handle. Slide it toward the top of the door. 2. Lift the basket off the holding buttons. To replace the basket in the door 1. Set the silverware basket on the holding buttons. 2. Slide the basket toward the bottom of the door until is locks into place. Cup shelves Fold down the extra shelf on the lefthand or right-hand side of the top rack to hold additional cups, stemware or long items such as utensils and spatulas. ANYWARE™ PLUS silverware basket The ANYWARE™ PLUS silverware basket can be hung on the door, the bottom rack, or placed inside the bottom rack. Door position Rack position Rack position side To open the ANYWARE™ PLUS silverware basket To unlock, grasp the front panel, pull up and rotate 90° as shown. Make sure the front panel is up all the way before rotating. To unlock and rotate the front panel, grasp the front panel as shown and pull it up and out. PUSH Fold-down Tines The row of tines on the lefthand and right-hand sides of the upper or in the back of lower rack can be adjusted to make room for a variety of dishes. To adjust the fold-down tines 1. Grasp the tip of the tine that is in the tine holder. 2. Gently push the tine out of the holder. 3. Lay the tines down, toward the center of the rack. Light Item Clips The light item clips hold lightweight plastic items such as cups, lids, or bowls in place during washing. To move a clip 1. Pull the clip up and off the tine. 2. Reposition the clip on another tine. NOTE: Be sure the front panel of the silverware basket is completely locked into place before pulling out the bottom rack and before closing the dishwasher door. 10

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52

10
Dishwasher Features
Your Whirlpool dishwasher may have some or all of these features.
TargetClean™ Wash Area
The TargetClean™ wash area is located at
the back of the lower level rack.
NOTE:
You must select the TargetClean™
wash option to use this feature. Make sure
items do not interfere with the water feed
tube, spray arms, or TargetClean™ spray
jets.
Load pans, casserole dishes, etc. in the
back of the lower dish rack with the soiled surfaces facing the
TargetClean™ spray jets.
Only one row of items may face the TargetClean™ spray jets.
Stacking, overlapping or nesting items will keep the
TargetClean™ spray jets from contacting all of the surfaces.
ANYWARE™ PLUS silverware basket
The ANYWARE™ PLUS silverware basket can be hung on the
door, the bottom rack, or placed inside the bottom rack.
To open the ANYWARE™ PLUS silverware basket
To unlock, grasp the front panel, pull up and rotate 90° as shown.
Make sure the front panel is up all the way before rotating
.
To
unlock and rotate the front panel, grasp the front panel as shown
and pull it up and out.
NOTE:
Be sure the front panel of the silverware basket is
completely locked into place before pulling out the bottom rack
and before closing the dishwasher door.
To remove the basket from the door
1.
Grasp the silverware basket by the handle. Slide it toward the
top of the door.
2.
Lift the basket off the holding buttons.
To replace the basket in the door
1.
Set the silverware basket on the holding buttons.
2.
Slide the basket toward the bottom of the door until is locks
into place.
Cup shelves
Fold down the extra shelf on the left-
hand or right-hand side of the top rack
to hold additional cups, stemware or
long items such as utensils and
spatulas.
Fold-down Tines
The row of tines on the left-
hand and right-hand sides
of the upper or in the back
of lower rack can be
adjusted to make room for a
variety of dishes.
To adjust the fold-down
tines
1.
Grasp the tip of the tine
that is in the tine holder.
2.
Gently push the tine out
of the holder.
3.
Lay the tines down, toward the center of the rack.
Light Item Clips
The light item clips hold lightweight plastic items
such as cups, lids, or bowls in place during
washing.
To move a clip
1.
Pull the clip up and off the tine.
2.
Reposition the clip on another tine.
To follow progress of
your dishwasher cycle.
NOTE:
Indicators shown
are not available on all
models.
The Clean indicator glows when a cycle is finished.
If you select the Sani Rinse option, when the cycle is finished, the “Sanitized” indicator
glows. If your dishwasher did not properly sanitize your dishes, the light flashes at the
end of the cycle. This can happen if the cycle is interrupted, or water could not be
heated to required temperature. The light goes off when you open and close door or
press CANCEL.
CONTROLS AND CYCLE STATUS
CONTROL
PURPOSE
COMMENTS
Door position
Rack position
Rack position side
Back of
dishwasher
PUSH