Whirlpool WDT920SADM Installation Guide - Page 21
Secure Dishwasher in Cabinet Opening
View all Whirlpool WDT920SADM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
Connect wires black to black and white to white, using UL Listed/CSA Approved twist-on wire connectors (not included). Secure Dishwasher in Cabinet Opening If needed, see website for animated representation of this step. Visit www.whirlpool.com/electrical under FAQ tab. Tighten strain relief screws to secure cable. Check that dishwasher is still level front-to-back and side-to-side in cabinet opening. Open dishwasher door, remove lower dish rack, and place towel over pump assembly and lower spray arm of dishwasher. This will keep screws from falling into pump area when you are securing the dishwasher. Place wires inside terminal box. Insert tabs on left side of cover. Make sure wires are tucked inside box. Close cover ensuring wires are not pinched. Use ¹⁄₄" nut driver or Torx® T20® screwdriver and previously removed screw to secure cover. NOTE: Do not drop screws into bottom of dishwasher. 21