Whirlpool WDT970SA Owners Manual - Page 18
DRAIN HOSE CONNECTION, Power cord Connection
View all Whirlpool WDT970SA manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
DRAIN HOSE CONNECTION 17. Connect drain hose Drain Hose Location 18. Remove terminal box Terminal box To remove the terminal box, depress the plastic latch, slide the box toward the left of the unit along the metal tube and rotate the left side of the box forward. Make sure that the product wiring is still attached within the terminal box. 19. Remove terminal box cover Terminal box cover Put provided silver clamp over elbow end of drain hose. Then push the hose onto the drain port (being sure to push all the way on) with the hose facing underneath the dishwasher. Using pliers, squeeze open the drain hose clamp and slide it over the elbow to ensure the hose is attached in place. Route the hose out of the back of the product. NOTE: ■ If the hose is installed with the rubber elbow facing out, the drain hose may become kinked causing slow or incomplete draining in tight cabinet installations. ■ There may be a plastic plug in the drain port for shipping purposes where you will connect the drain hose. Remove this plug before installing drain hose, if present. Using 1/4" (6.4 mm) nut driver remove the screw holding the terminal box cover. Remove the cover by lifting it out of the box. Keep the cover for later use. 20. Install strain relief POWER CORD CONNECTION NOTE: If installing a product with direct wiring, proceed to Step 25, wait to install wiring until after Step 44 when the unit has been installed in the cabinet opening. Select UL Listed/CSA Approved power cord for the Dishwasher. Power Cord Kit Kit typically includes power cord, metallic strain relief, grommet. (Whirlpool Part Number Cord Kit - Straight - W11365011 Cord Kit - Right Angle - W11365014) Install a UL Listed/CSA Approved metallic strain relief. Make sure screw heads are facing up when tightening conduit nut. Strain relief is provided with the power cord kit. Suggested wire length relative to strain relief 41/2" (114.3 mm) 0.75" - 1" (19 mm - 25 mm) 18