Whirlpool WED4800XQ Installation Instructions - Page 16

q When the dryer has been running for 5 minutes, open the dryer door and feel for heat. If you feel heat, cancel cycle and close the door. If you do not feel heat, turn off dryer, and check the following: ■■ There may be 2 household fuses or circuit breakers for the dryer. Check that both fuses are intact and tight, or that both circuit breakers have not tripped. If there is still no heat, contact a qualified technician. NOTE: You may notice an odor when the dryer is first heated. This odor is common when the heating element is first used. The odor will go away. Reverse Door Swing (Optional) If your door is the 29" Large Side-Swing Door, follow steps 1-6. 2. Remove bottom screws Open dryer door. Remove bottom screws from dryer cabinet side of hinges. Loosen (do not remove) top screws from dryer cabinet side of hinges. 3. Lift door off top screws If your door is the 29" Super Wide Side-Swing Door, follow steps 1-13. NOTE: Magnetized screw driver is helpful. Large Side-Swing Door 1. Place towel on dryer Lift door until top screws in cabinet are in large part of hinge slot. Pull door forward off screws. Set door on top of dryer. Remove top screws from dryer cabinet. 4. Remove and transfer hinge hole plugs Place towel on top of dryer to avoid damaging the surface. 16 Use a small, flat-blade screwdriver to gently remove 4 hinge hole plugs on left side of dryer cabinet. Insert plugs into hinge holes on opposite side of dryer cabinet.