Whirlpool WED8300SE Use and Care Manual - Page 21

WRINKLE SHIELD TM Feature The WRINKLE SHIELD TM feature helps smooth out wrinkles that form when you cannot unload the dryer promptly at the end of a cycle. During this option, the dryer stops tumbling and then tumbles again for a brief period. • Press the WRINKLE SHIELD TM feature to get up to 90 minutes of heat-free, periodic tumbling at the end of a cycle, • During the WRINKLE SHIELD TM feature, you may continue the option after opening and closing the dryer door by pushing START. • Cancel at any time by pressing the WRINKLE SHIELD TM feature button, NOTE: If you do not select the WRINKLE SHIELD TM feature, the dryer stops after the cool down period. Temperature Temperature settings are used with the Manual Cycles. Press TEMP ADJUST until the desired temperature setting illuminates. Temperature modifiers cannot be used with the Auto Cycles. HIGH LOW £XTRALOW RONLY TEMP ADJUST Air Only Use the Air Only modifier for items that require drying without heat such as rubber, plastic and heat-sensitive fabrics. This chart shows examples of items that can be dried using Air Only. Type of Load Time* (Minutes) Foam rubber - pillows, padded bras, stuffed toys 20 - 30 Plastic - Shower curtains, tablecloths 20 - 30 Rubber-backed rugs 40 - 50 Olefin, polypropylene, sheer nylon 10 - 20 *Reset time to complete drying, if needed. When using Air Only • Check that coverings are securely stitched. • Shake and fluff pillows by hand periodically during the cycle. • Dry item completely. Foam rubber pillows are slow to dry. NOTE: Auto Cycles are not available when you are using the Air Only setting. End of Cycle Signal The End of Cycle Signal produces an audible sound when the drying cycle is finished. Promptly removing clothes at the end of the cycle reduces wrinkling. ON ENDOF I CYCLSEIGNAIL Hold 3 secondsto,,I Lock/UnlockControl Press and release the END OF CYCLE SIGNAL to turn off the signal. Hold the END OF CYCLE SIGNAL for 3 seconds to lock or unlock this control. NOTE: When the WRINKLE SHIELD TM feature is selected and the End of Cycle Signal is on, an audible sound will be emitted every 5 minutes until the clothes are removed, or the WRINKLE SHIELD TM feature is finished. You can change Auto Cycles, Timed Cycles, Modifiers and Options anytime before pressing Start. • Three short tones sound if an unavailable combination is selected. The last selection will not be accepted. Changing Cycles after pressing Start 1. Press STOP twice. This ends the current cycle. 2. Select the desired cycle and options. 3. Press and hold START. The dryer starts at the beginning of the new cycle. NOTE: If you do not press Start within 5 minutes of selecting the cycle, the dryer automatically shuts off. Changing Modifiers and Options after pressing Start You can change a Modifier or Option anytime before the selected Modifier or Option begins. 1. Press STOP once. 2. Select the new Modifier and/or Option. 3. Press and hold START to continue the cycle. NOTE: If you happen to press Stop twice, the program clears and your dryer shuts down. Restart the selection process. Use the Drying Rack to dry items such as sweaters and pillows without tumbling. The drum turns, but the rack does not move. If your model does not have a drying rack, you may be able to purchase one for your model. To find out whether your model allows drying rack usage and for more information on ordering, please refer to the front page of the manual or contact the dealer from whom you purchased your dryer. NOTE: The rack must be removed for normal tumbling. Do not use the automatic cycle with the drying rack. 21