Whirlpool WED8300SE Use and Care Manual - Page 4

a1025.4cmpedestal - parts

Page 4 highlights

Areyouplacintghedryeor napedestaYl?ouhavetheoptionof purchasinpgedestaolsfdifferenhteightseparatefolyrthisdryer. Youmayselecat 10"(25.4cm)pedestoarl a 15.5("39.4cm) pedestwalithashelaf ndbindividerTs.hesepedestawlsilladdto thetotalheighotfthedryefroratotahl eighotfapproximat4e6ly" (116.c8m)or51.5"(130.c8m),respectively. Foragaragienstallatioyno,uwillneedtoplacethedryear tleast 18"(46cm)abovethefloor. Optional pedestal (15.5" [39.4 cm] model shown) To order, call the dealer from whom you purchased your dryer or refer to the "Assistance or Service" section. Pedestal Height Color Part Number 10" (25.4 cm) White WHP1000SQ 15.5" (39.4 cm) with shelf and bin dividers White WHP1500SQ Drying Rack To order a drying rack, call the dealer from whom you purchased your dryer or refer to the "Assistance or Service" section. Ask for Part Number 8563738. For more information, see "Drying Rack Option." Stack Kit Are you planning to stack your DUET SPORT TM washer and dryer? To do so, you will need to purchase a Stack Kit. To order, call the dealer from whom you purchased your dryer or refer to the "Assistance or Service" section. Ask for Part Number 8572546. Explosion Hazard Keep flammable materials and vapors, such as gasoline, away from dryer. Place dryer at least 18 inches (46 cm) above the floor for a garage installation. Failure to do so can result in death, explosion, or fire. You will need • A location that allows for proper exhaust installation. See "Venting Requirements." • A separate 30-amp circuit. • If you are using a power cord, a grounded electrical outlet located within 2 ft (61 cm) of either side of the dryer. See "Electrical Requirements." • A sturdy floor to support the total dryer weight of 127 Ibs (57.6 kg). The combined weight of a companion appliance should also be considered. A level floor with a maximum slope of 1" (2.5 cm) under entire dryer. (If slope is greater than 1" [2.5 cm], install Extended Dryer Feet Kit, Part No. 279810.) Clothes may not tumble properly and automatic sensor cycles may not operate correctly if dryer is not level. • For a garage installation, you will need to place the dryer at least 18" (46 cm) above the floor. If using a pedestal, you will need 18" (46 cm) to the bottom of the dryer. Do not operate your dryer at temperatures below 45°F (7°C). At lower temperatures, the dryer might not shut off at the end of an automatic cycle. Drying times can be extended. The dryer must not be installed or stored in an area where it will be exposed to water and/or weather. Check code requirements. Some codes limit, or do not permit, installation of the dryer in garages, closets, mobile homes or sleeping quarters. Contact your local building inspector.

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28

Areyouplacing
thedryer
onapedestal?
Youhave
theoptionof
purchasing
pedestals
ofdifferent
heightseparately
forthisdryer.
Youmayselect
a10"(25.4cm)pedestal
ora15.5"
(39.4cm)
pedestal
withashelf
andbindividers.
Thesepedestals
willaddto
thetotalheight
ofthedryer
foratotal
height
ofapproximately
46"
(116.8
cm)or51.5"(130.8
cm),respectively.
Foragarage
installation,
youwillneed
toplace
thedryer
atleast
18"(46cm)above
thefloor.
Optional
pedestal
(15.5" [39.4
cm] model shown)
To order, call the dealer from whom you purchased
your dryer or
refer to the "Assistance
or Service"
section.
Pedestal
Color
Part Number
Height
10" (25.4 cm)
White
WHP1000SQ
15.5" (39.4 cm) with
White
WHP1500SQ
shelf and bin dividers
Drying Rack
To order a drying
rack, call the dealer from whom you purchased
your dryer or refer to the "Assistance
or Service"
section.
Ask for
Part Number
8563738.
For more information,
see "Drying
Rack
Option."
Stack Kit
Are you planning to stack your DUET SPORT
TM
washer
and
dryer? To do so, you will need to purchase
a Stack Kit.
To order, call the dealer from whom you purchased
your dryer or
refer to the "Assistance
or Service"
section.
Ask for Part Number
8572546.
Explosion
Hazard
Keep flammable
materials
and vapors,
such
as
gasoline,
away
from
dryer.
Place
dryer
at
least
18
inches
(46 cm)
above
the floor
for a garage
installation.
Failure
to do
so
can result
in death,
explosion,
or fire.
You
will
need
A location
that allows for proper
exhaust
installation.
See
"Venting
Requirements."
A separate
30-amp
circuit.
If you are using a power
cord, a grounded
electrical
outlet
located
within 2 ft (61 cm) of either side of the dryer. See
"Electrical
Requirements."
A sturdy floor to support
the total
dryer weight
of 127 Ibs
(57.6 kg). The combined
weight
of a companion
appliance
should
also be considered.
A level floor with a maximum
slope of 1" (2.5 cm) under entire
dryer. (If slope
is greater than 1" [2.5 cm], install Extended
Dryer Feet Kit, Part No. 279810.) Clothes
may not tumble
properly
and automatic
sensor
cycles
may not operate
correctly
if dryer
is not level.
For a garage installation,
you will need to place the dryer at
least 18" (46 cm) above the floor. If using a pedestal,
you will
need 18" (46 cm) to the bottom
of the dryer.
Do not operate
your dryer at temperatures
below 45°F (7°C). At
lower temperatures,
the dryer
might not shut off at the end of an
automatic
cycle. Drying times
can be extended.
The dryer must not be installed
or stored in an area where it will
be exposed to water and/or
weather.
Check code requirements.
Some codes limit, or do not permit,
installation
of the dryer in garages,
closets,
mobile homes or
sleeping
quarters.
Contact
your local building
inspector.