Whirlpool WED9290FW Installation Guide - Page 16

Complete Installation Checklist q Check that all parts are now installed. If there is an extra part, go back through steps to see what was skipped. q Check that dryer is level. See "Level Dryer." q Check that you have all of your tools. q Dispose of/recycle all packaging materials. q Check dryer's final location. q Remove film on console and any tape remaining on dryer. q Wipe dryer drum interior thoroughly with a damp cloth to remove any dust. q Read "Dryer Use" in your Use and Care Guide. q For power supply cord installation, plug into a grounded outlet. For direct wire installation, turn on Power. q Select a Timed Dry heated cycle and start dryer. If dryer will not start, check the following: • Controls are set in a running or ON position. • Start button has been pushed firmly. • Dryer is plugged into an outlet and/or electrical supply. • Household fuse is intact and tight or circuit breaker has not tripped. • Dryer door is closed. This dryer automatically runs an installation diagnostic routine at the start of its first cycle. NOTE: You may notice an odor when dryer is first heated. This odor is common when heating element is first used. The odor will go away. Door Reversal (optional) The following instructions are for models with a round and square-shaped doors. Tools needed: Min. 8" long TORX T25® † screwdriver #2 Phillips screwdriver Reverse door swing curved glass - single handle 1. Remove door from dryer IMPORTANT: If the protective film has not yet been removed from the dryer, peel the film from the dryer door before proceeding. Using a T25® screwdriver, remove the 4 screws securing the door hinge to the dryer and lift up and out to remove the door. Place the door on a soft towel or other non-scratch surface. Reinstall the 4 screws in the holes. †® TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC. 16