Whirlpool WED92HEFU Installation Instructions - Page 13
Plan Vent System
View all Whirlpool WED92HEFU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
Rigid metal vent: ■■ Recommended for best drying performance and to avoid crushing and kinking. Flexible metal vent: (acceptable only if accessible to clean) ■■ Must be fully extended and supported in final dryer location. ■■ Remove excess to avoid sagging and kinking that may result in reduced airflow and poor performance. ■■ Do not install in enclosed walls, ceilings, or floors. ■■ The total length should not exceed 73/4 ft. (2.4 m). ■■ The length of flexible metal vent used must be included in the overall vent system design as shown in the "Vent System Charts." NOTE: If using an existing vent system, clean lint from entire length of the system and make sure exhaust hood is not plugged with lint. Replace plastic or metal foil vents with rigid metal or flexible metal vents. Review "Vent System Charts" and, if necessary, modify existing vent system to achieve best drying performance. Clamps: ■■ Use clamps to seal all joints. ■■ Exhaust vent must not be connected or secured with screws or other fastening devices that extend into interior of duct and catch lint. Do not use duct tape. Exhaust hoods: ■■ An exhaust hood should cap the vent to keep rodents and insects from entering the home. ■■ Must be at least 12" (305 mm) from ground or any object that may obstruct exhaust (such as flowers, rocks, bushes, or snow). Plan Vent System Choose your exhaust installation type Recommended exhaust installation: ■■ Do not use an exhaust hood with a magnetic latch. B C A D Recommended Styles: F E G Louvered Hood Acceptable Style: Box Hood Angled Hood Elbows: ■■ 45° elbows provide better airflow than 90° elbows. Good Better B H A. Dryer E. Clamps B. Elbow F. Rigid metal or flexible metal vent C. Wall G. Vent length necessary to connect elbows D. Exhaust hood H. Exhaust outlet 13