Whirlpool WED92HEFU Installation Instructions - Page 18
Door Reversal Optional
View all Whirlpool WED92HEFU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
DOOR REVERSAL (OPTIONAL) The following instructions are for models with round and square-shaped doors. Tools needed: 2. Move the door strike Min. 8" long TORX T25® † screwdriver #2 Phillips screwdriver Reverse door swing round-shaped door with flat glass - single handle 1. Remove door from dryer Using a T25® screwdriver, remove the 2 screws securing the door strike to the door frame of the dryer. Rotate the strike 180° and attach to the opposite side of dryer door frame as shown. 3. Remove inner door from outer door IMPORTANT: If the protective film has not yet been removed from the dryer, peel the film from the dryer door before proceeding. Using a T25® screwdriver, remove the 4 screws securing the door hinge to the dryer and lift up and out to remove the door. Place the door on a soft towel or other non-scratch surface. Reinstall the 4 screws in the holes. Position the door with the inside of the door facing up. Using a Phillips screwdriver, remove the 10 screws securing the inner door to the outer door. Lift off the inner door and set aside. †®TORX and T25 are registered trademarks of Acument Intellectual Properties, LLC. 18