Whirlpool WFG361LVS Installation Instructions - Page 13

Storage Drawer The storage drawer can be removed. Before removing, check that the storage drawer is cool and empty. A flat-blade screwdriver will be needed for removal. To Remove: 1. Pull the storage drawer forward to the drawer stop. Push the drawer back approximately 1" (2.5 cm). It will be necessary to disengage the storage drawer one side at a time. 2. Insert a flat-blade screwdriver through the opening in the side of the storage drawer, placing the screwdriver tip on the outside of the drawer clip. To Replace: 1. Lift up the back of the storage drawer and place it inside the range in its fully forward position. 2. Lift up the front of the storage drawer to a level position. 3. Slowly push the storage drawer into the range until the drawer side rails engage with the gap in the drawer glides. A A A. Drawer clip 3. Depress the drawer clip by pressing the screwdriver handle toward the side of the storage drawer. A A. Drawer clip - view from outside of storage drawer 4. Gently pull forward on the storage drawer until the depressed clip clears the drawer glide. 5. Repeat steps 2-4 for the other side of the storage drawer. 6. Lift up the back of the storage drawer and remove. A. Engage drawer glide. 4. Once the storage drawer is fully engaged on both sides, slide the drawer back into the closed position. 5. NOTE: When you are removing and replacing the storage drawer, a slight push may be needed to move the drawer stop notch past the drawer glides. Complete Installation 1. Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped. 2. Check that you have all of your tools. 3. Dispose of/recycle all packaging materials. 4. Check that the range is level. See "Level Range." 5. Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by shipping material. Dry thoroughly with a soft cloth. For more information, see the "Range Care" section of the Use and Care Guide. 6. Read the Use and Care Guide. 7. Turn on surface burners and oven. See the Use and Care Guide for specific instruction on range operation. If range does not operate, check the following: ■ Household fuse is intact and tight, or circuit breaker has not tripped. ■ Range is plugged into a grounded 3 prong outlet. ■ Electrical supply is connected. ■ See "Troubleshooting" in the Use and Care Guide. 8. When the range has been on for 5 minutes, check for heat. If the range is cold, turn off the range and check that the gas supply line shutoff valve is open. ■ If the gas supply line shutoff valve is closed, open it, then repeat the 5-minute test as outlined above. ■ If the gas supply line shutoff valve is open, press the CANCEL button on the oven control panel and contact a qualified technician. If you need Assistance or Service: Please reference the "Assistance or Service" section of the Use and Care Guide or contact the dealer from whom you purchased your range. 13