Whirlpool WFW3090GW Installation Guide - Page 17

INSTALLATION INSTRUCTIONS Optional tools: Installation Requirements Tools and Parts Gather required tools and parts before starting installation. Tools needed: Flashlight Bucket Adjustable or open-end wrenches 3/8" (10 mm) and 1/2" (13 mm) 4" min (102 mm) Level Wood block Ruler or measuring tape Pliers that open to 19⁄16" (39.5 mm) 3/8" (10 mm) socket wrench Parts supplied: NOTE: All parts supplied for installation are in the washer drum. Inlet hoses and washers are not included. Alternate parts: (Not supplied with washer) Your installation may require additional parts. To order, please refer to toll-free numbers on the back page of this manual. If you have: You will need: Laundry tub or standpipe Sump pump system taller than 55" (1.4 m) (if not already available) Overhead sewer Standard 20 gal. (76 L) 30" (762 mm) tall drain tub or utility sink, sump pump and connectors (available from local plumbing suppliers) Floor drain system Siphon Break Kit Part Number 285834 Connector Kit (x2) Part Number 285835 Additional Drain Hose Part Number 8318155 Drain hose too short Extension Drain Hose Part Number 285863 Connector Kit Part Number 285835 Water faucet beyond reach of fill hose 2 longer water fill hoses: 6 ft (1.8 m) Part Number 76314 10 ft (3.0 m) Part Number 350008 Available accessories: n A Stack Kit is available to stack your washer and dryer. n An optional matching pedestal is available to raise your washer to a more comfortable working height. To order, call the dealer from whom you purchased your washer or refer to the "Assistance or Service" section. Cable tie U-shaped hose form Transport bolt hole plugs (4) 17